Unpacking Instructions; Grounding Instructions; Cleaning Instructions - Weston PRO Serie Instrucciones De Montaje

Ocultar thumbs Ver también para PRO Serie:
Tabla de contenido
Idiomas disponibles

Idiomas disponibles

UNPACKING INSTRUCTIONS

. Remove all parts from packaging material and check to be sure there are no
missing parts.
. Retain packaging material for storage of the Grinder and Grinder parts when
not in use.

GROUNDING INSTRUCTIONS

GROUNDING
This appliance must be grounded while in use
to protect the operator from electrical shock.
The appliance is equipped with a 3-conductor
cord and a 3-prong grounding type plug to fit
the proper grounding-type receptacle. The
appliance has a plug that looks like Figure
A. An adapter, Figure B, should be used
for connecting Figure A plugs to two-prong
receptacles. The grounding tab which extends
from the adapter must be connected to a
permanent ground such as a properly grounded
outlet box as shown in Figure C using a metal
screw.
EXTENSION CORDS
Use only 3-wire extension cords which have
3-prong grounding-type plugs and a 3-pole
cord connector that accepts the plug from the
appliance.
Use only extension cords having
an electrical rating not less than the rating of
the appliance. Do not use damaged extension
cords. Examine extension cord before using and
replace if damaged. Do not abuse extension
cord and do not yank on any cord to disconnect.
Keep cord away from heat and sharp edges.
8

CLEANING INSTRUCTIONS

WARNING!
Grinder, make sure the Grinder Motor is OFF and the PLUG IS REMOVED
FROM THE OUTLET/POWER SOURCE!
1. See page 17 for instructions on using the Auger Grabbing Stomper to
disassemble the head.
2. Separate the head from the body.
3. Remove the Safety Guard from the Tray. Safety Guards only come with #22 and
#32 Model Grinders.
FIGURE A
4. Wash all parts that have come in contact with meat in hot soapy water. BE
SURE TO CLEAN IMMEDIATELY AFTER USE. DO NOT IMMERSE THE
MOTOR IN WATER OR OTHER LIQUIDS!
5. Rinse the Grinder parts with clean hot water, then dry them IMMEDIATELY.
Grounding
6. Fully lubricate the Head, Plates and the Knife with a food grade silicone
Prong
spray before and after each use.
Circuit
Grounding
Conductor
7. Clean the Motor Cover and Gear Housing with a damp towel and wipe dry. DO
NOT IMMERSE THE MOTOR IN WATER OR OTHER LIQUIDS!
FIG RE B
IMPORTANT: Any metal parts should be coated with a food safe silicone spray
to prevent rusting. If not properly protected, these parts can begin to rust very
quickly. DO NOT use rusted parts. Ordering information can be found on the
Metal
last page of this instruction manual.
Grounding
Screw
8. Make sure the grinder and all components are completely dry before assembling
or storing.
Cover of
Grounded
Outlet Box
FIGURE C
Grounding
Means
AA2220
Before cleaning, assembling or disassembling the
WARNING!
NEVER operate Grinder without the
Tray/Safety Guard secured in place.
To avoid serious or fatal injury, NEVER reach
into any Grinder inlet.
ALWAYS use the Stomper to push meat
into the Grinder Head.
Read & fully understand all instructions
& warnings prior to use.
9
Tabla de contenido
loading

Este manual también es adecuado para:

10-0501-w10-0801-w10-1201-w10-2201-w10-3201-wPro serie

Tabla de contenido