Cleaning & Maintenance; Environmental Protection; Technical Specifications - Metabo SRE 4350 TurboTec Instrucciones De Manejo

en ENGLISH
6.3 TurboBoost switch
Actuate the TurboBoost switch (3) during operation
to switch on additional power reserves for maximum
material removal rate.
6.4 Dust extraction
To optimise the dust extraction performance, fit the
sanding disc such that the holes on the sanding disc
(9) and sanding plate (11) are aligned.
Own extraction system:
Fit the dust collection box (6) onto the exhaust nozzle
until it engages. To remove it, pull out the dust collec-
tion box (6).
To optimise the extraction performance, empty the
dust collection box (6) in good time and clean the
filter (8).
External dust extraction:
Fit a suitable dust extractor.
7. Cleaning, Maintenance
Empty dust collection box (6).
- Open cleaning flap (7).
- Remove fluted filter (8) and knock off dust stuck to
filter or remove with brush.
You can also clean fluted filter (8) under running water (but make sure to dry the filter before use!).
- Empty the dust collection box (6), clean it thor-
oughly and ensure that any remaining dust is
removed.
- When inserting, ensure that the fluted filter (8) is
inserted in the lateral guides.
Clean the machine regularly. This includes
vacuum cleaning the ventilation louvres on the
motor.
Replacing worn sanding plate (11)
- Remove fixing screws (on lower side of sanding
plate).
- Take off sanding plate.
- Sanding plate (as a spare part), see page 2.
- Mount sanding plate.
- Re-insert the fixing screws on the lower side of the
sanding plate (the screw must be inserted in the
existing thread pitch) and tighten (tightening torque
= 3.5 Nm +/- 0.2 Nm).
8. Accessories
Use only genuine Metabo accessories.
For a complete range of accessories, see
www.metabo.com or the main catalogue.
9. Repairs
Repairs to electrical tools must be carried out by
qualified electricians ONLY!
If the mains connection cable of this machine is
damaged, it must be replaced by the manufacturer or
an authorized service centre to avoid hazard.
If you have Metabo electrical tools that require
repairs, please contact your Metabo service centre.
For addresses see www.metabo.com.
You can download spare parts lists from
www.metabo.com.
6

10. Environmental Protection

Observe national regulations on environmentally
compatible disposal and on the recycling of disused
machines, packaging and accessories.

11. Technical Specifications

Explanatory notes on the specifications on page 3.
Changes due to technological progress reserved.
A = Dimensions of sanding plate
P = Nominal power input
1
P = Power output
2
I = Current at 120 V
120 V
n = Idle speed (setting wheel)
0
n = Idle speed (TurboBoost switch)
0, TB
n = Speed at rated load (TurboBoost
1, TB
switch)
s = Oscillating frequency at idle speed
0
(setting wheel)
s = Oscillating frequency at idle speed
0, TB
(TurboBoost switch)
s = Oscillating frequency at rated load
1, TB
(TurboBoost switch)
S = Oscillating circuit diameter
m = Weight without mains cable
The technical specifications quoted are subject to
tolerances (in compliance with the relevant valid
standards).
Wear ear protectors!