Ironing; Cleaning - Silvercrest SDRB 1000 C1 Instrucciones De Servicio

__NAS279803_Dampfbuerste_B5.book Seite 46 Donnerstag, 23. Juni 2016 10:35 10
6.6

Ironing

FIRE HAZARD!
Before turning the device on, place it on
a level, stable, dry, heat-resistant sur-
face.
DANGER! Risk of injury
through burning!
The sole plate 14 becomes very hot.
Only touch the handle 8 and control el-
ements of the device during operation.
NOTES:
• The sole plate 14 cools down slightly
while you are ironing and therefore has
to be repeatedly heated back up to the
set temperature. During the heating pro-
cess the control lamp 7 lights up. You
can continue ironing at the same time.
• Sensitive fabrics are ironed at lower
temperatures and without steam.
1. Set the temperature controller 4 to
MIN.
2. Connect the mains plug 10 with the
wall socket.
3. Set the desired temperature using the
temperature controller 4. The control
lamp 7 lights up.
4. Start ironing as soon as the ironing
temperature has been reached and the
control lamp 7 goes out.
5. Finish ironing, set the temperature con-
troller 4 to MIN and pull out the mains
plug 10.
6. Allow the device to cool down.
7. Open the cover 2 over the filler open-
ing 3.
8. Pour any remaining water out of the
water tank 1 through the filler open-
ing 3.
46 GB

7. Cleaning

DANGER! Risk of electric
shock!
Pull the mains plug 10 out of the wall
socket before you clean the device.
DANGER! Risk of injury
through burning!
Allow the device to cool down before
cleaning.
CAUTION:
Do not use any astringent or abrasive
cleaning agents.
Cleaning the device
• For cleaning the device, use a soft,
moistened cloth.
• Dirt can be removed from the sole
plate 14 using commercially available
cleaning agents for chrome, silver or
stainless steel.
• Residues that have melted on the sole
plate 14 can be removed by heating the
device up to the MAX setting and then
ironing on an old cotton cloth.
Descaling
If the steam power is reduced after a certain
time, please descale the device.
• You should use a commercially availa-
ble limescale remover that is based on
citric acid to descale the iron. Please
follow the instructions for the limescale
remover.
1. Pour the descaling solution into the wa-
ter tank 1.
2. Set the temperature controller 4 to
MAX.
3. Allow the descaling solution to work.
4. Press the steam jet button 11 and use
the steam brush to iron over an old cot-
ton cloth.