Liability; Disposal And Recycling; Electromagnetic Compatibility; Electromagnetic Emissions - ACTEON Mini LED Black Manual De Uso

VIII – LIABILITY
The manufacturer is not liable if:
- the manufacturer's recommendations have not been followed (electromagnetic environment, etc.);
- repairs have been performed by persons not authorized by the manufacturer;
- the device has been used in a way which is not stipulated in this Manual;
- accessories other than those supplied by SATELEC have been used;
- the instructions in this document have not been followed.
The manufacturer reserves the right to modify the unit and/or the Operating Manual without notice.
IX – DISPOSAL AND RECYCLING
As electrical and electronic equipment, the device must be disposed of according to a specialized procedure for
collection and recycling or destruction (in particular on the European market, with reference to Directive 2002/96/EC
of 27/01/2003).
When your device reaches the end of its life, we consequently recommend that you contact your dental equipment
dealer (or, failing this, the nearest ACTEON GROUP office), for information on how to proceed.
X - ELECTROMAGNETIC COMPATIBILITY
Important : The Mini LED Black is compliant with current electromagnetic compatibility standards.
The device requires special precautions to be taken with regard to electromagnetic compatibility.
It must be installed and prepared for use as described in chapter 4.
Certain types of mobile telecommunication devices such as mobile telephones are likely to interfere with the device.
The recommended separation distances in this paragraph must therefore be complied with.
The device must not be used near or on top of another device.
If this cannot be avoided, its operation under the conditions of use must be checked beforehand.
The use of accessories other than those specified or sold by SATELEC as replacement parts may have the consequence
of increasing the emissions or decreasing the immunity of the device.

10.1 - Electromagnetic emissions

The device is intended for use in the electromagnetic environment specified in the table below.
The user and/or installer must ensure that the device is used in such an environment.
Emission test
RF emission - CISPR
11.
10.2 - Magnetic and electromagnetic immunity
The device is intended for use in the electromagnetic environment specified in the table below.
Compliance
The device uses RF energy for internal operation.
Therefore, its radiofrequency emissions are very low and are not likely to cause any
interference in nearby equipment.
Group 1
Class B
The device is suitable for use in all establishments, including domestic establishments and
those directly connected to the public low voltage power supply network that supplies
buildings used for domestic purposes.
Electromagnetic environment - guidance
9