Tabla de contenido
Idiomas disponibles
Idiomas disponibles
2610051564_GAS20-17A 5/8/18 1:18 PM Page 16
▶ Water Level Sensor
Maintenance
Clean the water level sensors
occasionally:
A.
Unlock the canister latches 4 and
remove the control unit 1 (Fig. 1).
B.
Turn the control unit 1 upside
down and clean the water level
sensors 18 with a soft cloth (Fig.
10).
C.
Reattach the control 1 unit again
D.
Lock the canister latches 4.
▶ Service
be performed by a Bosch Factory
Service Center or Autho rized Bosch
Service Station. Service performed by
unauthorized per so n nel may result in
misplacing of internal wires and
components which could cause
serious injury.
▼ TOOL LUBRICATION
Your Bosch tool has been properly
lubricated and is ready to use.
▶ Cleaning
the tool from the power supply
before cleaning or performing any
main tenance.
Maintenance
P r e v e n t i v e
maintenance must
To avoid accidents
always dis connect
Fig. 10
18
Ventilation openings and switch
levers must be kept clean and free of
foreign matter. Do not at tempt to
clean by inserting pointed objects
through openings.
Wipe dust off dust extractor control
unit with moist cloth. Use water to
clean the canister and attachments.
Do not use dust extractor until
completely dry.
damage plastic parts. Some of these
are: gasoline, carbon tetrachlo ride,
chlo rinated
ammonia and house hold detergents
that contain ammonia.
16
1
4
Certain cleaning
agents and sol vents
cleaning
solvents,
Tabla de contenido
