Rothenberger RO ID400 Instrucciones De Uso página 21

Setting the direction of rotation, engaging the transporting safety device (switch-on lock):
Do not actuate the rotation selector switch or engage the transportation lock (2)
unless the motor has stopped completely!
 Actuate the rotation selector switch / Engage the transportation lock (2).
R = Right rotation set (insert screws)
L = Left rotation set (remove screws)
0 = Central position: transportation lock setting (switch-on lock)
Switching on and off:
 Switching on: press the trigger switch (3).
 Switching off: release the trigger switch (3).
Speed / Tightening torque:
The speed and tightening torque are connected directly. The lower the speed, the lower the
tightening torque.
The speed and tightening torque can be adjusted steplessly by pressing the trigger (3) firmly or
lightly, thus adapting to working conditions.
You can use the setting wheel (5) on the RO ID400 to adjust the rotational speed and tightening
torque (12 stages).
Recommendation: determine the correct setting by carrying out trial screwdriving.
Changing screwdriving bits:
 Inserting screwdriving bit. Fit the tool on the square attachment (1) until the limit stop.
 Removing screwdriving bit: Pull the tool from the square attachment (1).
The screwdriving bit used must match the screw!
Damaged screwdriving bits must not be used!
 Attaching the belt hook /bit depot.
RO BC14/36 Charger, RO BP18/2 and RO BP18/4 battery (fig. B):
Before plugging in, check to see that the rated mains voltage and mains fre-
quency, as specified on the rating label, match your power supply.
Devices such as this one, which generate direct current, may have an effect on basic residual-
current circuit breakers. Use type F or better, with a release current of max. 30 mA.
Before commissioning the charger, ensure that the air slots are free. Minimum
distance to other objects is 5 cm.
Self-test:
 Insert mains supply plug.
The warning display (4) and the operating indicator (3) light up one after the other for approx. 1
second and the installed fan runs for approx. 5 seconds.
Battery pack:
Charge the battery pack before use (1).
If performance diminishes, recharge the battery pack.
The ideal storage temperature is between 10°C and 30°C. The permissible storage temperature
is between 0°C and 50°C.
Attach the belt hook to the right (8), as shown. Attach the
bit depot to the left (9), as shown.
ENGLISH 17