Tabla de contenido
Idiomas disponibles
Idiomas disponibles
Note:
Trim is not rotated 180°. Freezer trim does not
have plastic tab or alternate trim for stainless
steel models.
A
B
C
A Top door cap
B Freezer hinge plug
C Handle
D Mounting tabs
• Replace top door cap with Torx-head driver.
6. Replace doors.
• Rehang freezer door by setting freezer door hinge
hole on bottom hinge pin.
• Install center hinge pin in center hinge bracket with
hex nut driver. Place center hinge door closure on
center hinge pin.
• Locate 3 plugs at top of cabinet. Transfer plugs to
holes left by hinge removal.
• Locate new top hinge found in literature assembly.
Install top hinge on opposite side of refrigerator
cabinet with shims from discarded hinge. Install rear
screws loosely with a
refrigerator door on center hinge door closure. Install
remaining screw and secure in place with Phillips
driver. Install new hinge cover and screw in place
with screw from previous hinge cover removal
• Use a dime to space door
cabinet. Use plastic shims behind center hinge to
provide more space if required.
• Handle side of door should be approximately
mm) higher than hinge side of door. Door will
become level when it is loaded with food.
11/16"
(18 mm)
7. Check unit for proper leveling following instructions in
section titled Leveling Refrigerator , starting with step
three.
G
D
F
E
E Bottom door cap
F Door stop
G Trim
5
/
" hex nut driver. Set
16
11
/
" (18 mm) from
16
1
/
1/8"
(3 mm)
Install Decorator Panels (some models)
To avoid personal injury or property damage, fresh food
panel should not weigh more than 30 lbs (14 kgs) and
freezer panel should not weigh more than 15 lbs (7 kgs).
If raised panels are used, allow 2½" minimum clearance
between raised edge of panel and refrigertor handle.
A
A
A 2½" clearance from raised panel edge to edge of door.
B Raised panel–41" x 35
C Raise panel–23
1.
Remove top door cap and handle of refrigerator door.
Slide panel into groove provided by bottom door cap.
When replacing handle, press panel flat against door and
slide handle down so that overlapping edge of handle
slides over panel to secure it. Replace door cap.
" (3
8
A Refrigerator door panel
2. Open door 90° and unscrew freezer top door cap.
Close door. Slide trim forward until free from door.
Open door. Remove door handle per step 5.
7
!
WARNING
5
/
" (104 cm x 90.5 cm)
8
11
/
" x 35
5
/
" (60.2 cm x 90.5 cm)
16
8
A
B
B Refrigerator handle
B
C
Capítulos
Tabla de contenido
