• Remove 2 plugs from hinge side of freezer door
and transfer to opposite side to fill holes left from
handle removal.
A
A Handle
B Handle cap
3. Remove doors.
• Remove top hinge cover. Top hinge cover snaps off.
Remove top hinge and hinge shim using
driver. Remove and retain all shims.
A
B
C
A Top hinge cover
5
B
/
" hex nut screws
16
• Remove refrigerator door by lifting door off door
closure on center hinge pin assembly. Inspect door
to verify all shims are with pin assembly.
• Remove and retain door closure from top of center
hinge pin assembly. Remove assembly using ¼"
hex nut driver. Due to tight fit of pin, firm pressure
may need to be applied. Remove and retain all
washer shims.
A
D
B
C
A Door closure
B Center hinge pin assembly*
• Remove freezer door by lifting door off bottom
hinge. An internal support rod may slide out of hinge
socket. Remove from hinge socket and transfer rod
to opposite side of freezer door.
A Support rod
(some models)
B
C
D
C Screws
D Plug
5
/
" hex nut
16
D
C Top hinge
D Hinge shim
C Center hinge
D Washer shims
* Hinge pin may come assembled
or as separate parts
A
4. Remove center hinge.
• Remove center hinge bracket and shims by
removing screws using a Phillips screwdriver.
• Remove 3 screws opposite of center hinge and
transfer to opposite side of cabinet.
• Install bracket on left side of cabinet with shims.
A
B
A Phillips screws
B Center hinge
5. Reverse lower hinge pin and closure.
• Move bottom hinge pin and door closure from
bottom hinge to opposite bottom hinge. Move
plastic blugs from bottm hinge to opposite hinge
using needle-nose pliers. Pinch tabs from underside
of hinge to remove.
A
A Left side
6. Reverse door stops.
• Locate door stop at bottom edge of refrigerator door.
Unscrew two Phillips screws to remove door stop.
Remove the two Phillips screws on opposite edge
of door. Mount door stop on opposite side. Replace
remaining screws in empty mounting holes.
• Repeat the above instructions to reverse door stop
on freezer door.
A
A Screws
7. Replace doors.
• Rehang freezer door by setting left freezer door
hinge hole on bottom left hinge pin.
Install center hinge pin in center hinge bracket with
hex nut driver. Place center hinge door closure on
center hinge pin.
• Locate 3 plugs at top of cabinet. Transfer plugs to
holes left by hinge removal.
• Replace top hinge on opposite side of refrigerator
cabinet by installing rear screws loosely with a
hex nut driver. Set refrigerator door on center hinge
door closure. Install remaining screw and tighten all
screws. Snap on hinge cover.
• Use a dime to space door
cabinet. Use plastic shims behind center hinge to
provide more space if required.
• Handle side of door should be approximately
mm) higher than hinge side of door. Door will
become level when it is loaded with food.
4
C
C Center hinge shim
B
B Right side
B
A
B Door stop
5
/
"
16
11
/
" (18 mm) from
16
1
/
" (3
8