How To Install And Remove Handles - Amana XRSR687BW El Manual Del Propietario

How to Install and Remove Handles

Handles are located within fresh food section of refrigerator. Trim, plugs, and accent pieces will be located within the
literature assembly.
Full-Length Grab Handles (non-stainless steel)
1
1
Remove two / " hex nut
4
screws from bottom of
refrigerator
and freezer door.
2
Align door handles with top
and bottom sets of door clips,
and slide down until screw
holes on bottom of handles
match with door screw holes.
Half-Length Grab Handles (non-stainless steel)
1 1
Remove four / " hex nut
4
screws from top and
bottom of doors.
2
Align door handles with
screw holes and insert screws
removed in step 1.
To avoid risk of serious personal injury from sharp edges, use extreme caution when removing & installing handles.
Stainless Steel Models
1
Loosen lower door clip on
refrigerator door with
hex nut driver.
2
Locate predrilled hole at
base of handle, and fit
hollow end of handle over
lower door clip.
Installing Your Refrigerator
!
WARNING
1
/ "
4
3
Insert screws removed in step 1
into screw holes at bottom of
handle section.
4
Snap trim over bottom portion
of handles and retainers on
bottom of door
To remove after initial install...
• Follow steps 3 through 4 in reverse order.
NOTE: Fit may be tight. When removing handle, pull up and
out.
3
Snap colored handle trim over
screw holes at top and bottom of
handles.
• Snap in trim by inserting large round
end first.
To remove after initial install...
Handles may need to be removed if transporting unit
through tight spaces.
• Follow steps 2 and 3 in reverse order.
IMPORTANT: To avoid damage to handle, use a
flat blade screwdriver edge wrapped in masking
tape to remove colored handle trim.
3
Fit other end of handle over
upper door clip and slide
up as far as possible.
4
Insert 1 / " hex nut driver into
4
predrilled hole at base of handle
and tighten screw.
5