3. Reverse lower hinge pin and closure.
• Move bottom hinge pin and door closure from right
bottom hinge to left bottom hinge. Move plastic
plugs from left bottom hinge to right bottom hinge
using needle nose pliers. Pinch tabs from underside
of hinge to remove.
A
A Left side
4. Remove door stops and reverse door extensions.
• Locate door stop and bottom of refrigerator door and
freezer door. Remove with Phillips screwdriver.
A
A Bottom door cap
B Screws
• Unscrew door extension on top of door with Phillips
screw driver. Flip door extension and reinstall.
A
A Before
C Door extension
5. Reverse handles.
• Remove bottom door cap with Phillips screwdriver.
• Using a soft rubber mallet, tap bottom of handle
upward toward top of door. Handle will slide up
approximately ¾" and release from door.
• Using a soft rubber mallet, tap bottom of door hinge
trim upward toward top of door. Trim will slide up
approximately ¾" and release from door.
• Turn trim 180° and remove plastic tab on top of trim.
Return tab to literatature assembly. Locate alternate
tab piece in literature assembly and place this in
notch at bottom end of trim.
B
B Right side
C
B
C Door stop
C
B After
• Replace bottom door cap and transfer door stop to
opposite side.
• Locate underside of new hinge side of door. Replace
door stop with Phillips screws.
• Install hinge trim* by locating notches on the inside
of trim(make sure plastic tab insert is facing bottom
of door). Align notches of trim with metal mounting
tabs on opposite side of door. Slide trim down until
piece locks into place. Tap top of trim with rubber
mallet to insure snug fit.
* In stainless steel models, replace trim with alternate trim
shipped with unit.
• Reinstall handle by locating notches on inside of
handle trim. Slide handle down until handle locks
into place. Tap top of handle with rubber mallet to
insure snug fit. End of trim should be flush with top
of door.
B
A Trim
B Refrigerator handle
• Fasten top door cap securely over top of door and
replace screws.
• Remove top door cap of freezer by removing 4 T-15
Torx screws from top of freezer door
• Verify that internal support rod has been moved
to new hinge side of door.
• Move hinge plug on top of door to new handle side
of door.
• To reverse freezer handle and trim, follow step 5.
6
Right
mounted
handle
Left
mounted
handle
A
C
C Mounting tabs
B