Introduction; Care Of The Manual - Sun BREEZE II Manual De Instrucciones

INTRODUCTION

This machine is a pressure unit as can be seen in the CE declaration of conformity and
Data plate. The equipment supplied conforms to the Essential Safety Requirements
according to Annexure I of Directive 97/23/CE (PED). Any work involving repairs,
modifications, and/or changing pressurised components or parts make safe use of the
equipment very risky. Any tasks done must be authorised by the Manufacturer.
This manual contains important information pertinent to operator
safety. Read this manual through before beginning operation of the
machine.
The manufacturer reserves the right to modify this manual and the machine itself with no prior
notice. We therefore recommend checking any updates. This manual must accompany the
machine in case of sale or other transfer.
Any repair, modification, or changing of components not formally agreed with and authorised
by the manufacturer poses a risk of the conformity to Directive 97/23/CE being nullified and
makes this pressure equipment a significant risk. If not authorised in writing the Manufacturer
considers the tasks indicated above to be tampering with the machine, which nullifies the initial
declaration of conformity issued, and so they do not accept any direct responsibility.
Braze welding of parts that contribute to the pressure strength of the equipment and the parts
directed attached to it was done by adequately qualified personnel, using adequate operating
methods. Approval of the operating methods and personnel was entrusted to a competent
outside party for category II and III pressure equipment, and any work on this equipment that
involves the need to carry out braze welding must comply with the requirements laid down in
ann. 1 of Directive 97/23/CE, or the Manufacturer must be contacted for the relevant
information.
− The pressure equipment has been inspected and tested, complete with the safety
accessories identified by the manufacturer as being of a direct discharge type with
calibrated air pressure. Testing and inspection of the accessories is not necessary prior
to starting up.
− The pressure equipment must be subjected to routine inspections and checks when
operating, according to the relevant regulations and legal norms.
For the unit in question, it is hereby declared that a competent Authorised Body carried out
their part of the final check according to ann. I of point 3.2.3 of Directive 97/23/CE as well as
checking safety accessories and control devices in conformity to comma d) of art 5 of
Ministerial Decree 329 of 01/12/2004.
List of the critical components in terms of PED safety DIR 97/23/CE
Condenser, dehydrator filters, distributor, refrigerant storage bottle, airtight compressor, safety
pressure switch, pressure transducers, and safety valves.

CARE OF THE MANUAL

This manual must be kept for the entire life of the machine and protected against humidity and
excessive heat. Take care not to damage this manual in any way during consultation.
INSTRUCTIONS MANUAL
-5-