Filling The New Oil Container; Emptying The Used Oil Container; Replacing The Printer Paper - Sun BREEZE II Manual De Instrucciones

FILLING THE NEW OIL CONTAINER

It is good practice to fill the oil tank whenever the oil level falls below 100 cc in order to
guarantee that there will be sufficient oil for topping up during successive operations. Types of
oil: use only synthetic oils.. Always refer to the information provided by the A/C system
manufacturer. Procedure: Grasp the quick-connect coupling near the top of the tank and
remove the tank complete with cap. Unscrew the cap and fill the tank with the correct quantity
of oil for compressors, of suitable type and grade. Screw the cap back on and, grasping the
quick-connect coupling as above, replace the tank in its seat.

EMPTYING THE USED OIL CONTAINER

This operation must be performed whenever the oil level exceeds 200 cc. Procedure: remove
the container from its lodging very carefully and without exerting pressure on the scale.
Unscrew the container while holding the cap in place; empty the used oil into a suitable
container for used oils. Screw the container back on while holding the cap in place. Carefully
replace the container in its lodging without exerting pressure on the scale. N.B.: In order to
avoid damage to the oil scale, never exert pressure on it either from above or from below.

REPLACING THE PRINTER PAPER

Use only heat-sensitive paper of the type described below.
Paper width: 58 mm
Maximum paper roll diameter: 40mm
INSTRUCTIONS MANUAL
-35-