kiwy SLF 23 Manual De Instrucciones página 16

Verify that the seat belt is not twisted and that the excess of seat belt is
recovered by the seat belt retractor in the different conditions of regu-
lation. In case of doubt contact the retailer or the manufacturer.
ATTENTION: The backrest of the child car seat has to adhere to the seat
of the vehicle (Fig. 5). If necessary, remove the car seat headrest.
Use of the child car seat according to Method 1
Install the child car seat on the appropriate vehicle seat.
Make sure the vehicle seat is upright and in its rearmost position.
After placing the child in the child car seat, fasten the vehicle safety belt,
passing the lap and diagonal sections of the safety belt, respectively,
over the pelvis and the chest of the child (Fig.6 ).
The diagonal section of the safety belt part must be inserted in the
backrest belt-guide above the child's shoulder.
Always ensure the excess length of safety belt is recovered by the re-
tractor, accompanying the diagonal section of the safety belt in an up-
ward direction, making sure it is not twisted.
Use of the child car seat according to Method 2
SLF 23 comes with plastic guides (that you can use should your vehicle
not have any) so as to guide the Isofix connectors in their appropriate
position in correspondence with your car seats' anchorage points .
Apply the two plastic guides onto the Isofix anchoring points ( Fig.9).
Insert the two Isofix connectors in the guides ( Fig.10).
Click both Isofix connectors to the Iso-fix anchor points ( Fig.11) .
IMPORTANT: Make sure that both connectors are properly attached to
the Isofix anchor points (you should clearly hear two "clicks").
When the Isofix connectors are properly attached, the safety indicator (A)
on each side of the Isofix connectors group is completely green( Fig.11) .
Complete the installation by using the car safety belts, following the
instructions indicated above in Method 1 .
To release the Isofix connectors ( Fig.12 ):
Press both release devices (B) as shown in the illustration.
To operate in a better condition, you may move the backrest slightly
upwards.
6