DeWalt D26411 Manual De Instrucciones página 22

ENglIsh
setting applications
Low • Drying paint and varnish
• Removing stickers
• Waxing and dewaxing
• Drying wet timber prior to filling
• Shrinking PVC wrapping and
insulation tubes
• Thawing frozen pipes
Medium • Welding plastics
• Bending plastic pipes and sheets
• Loosening rusted or tightly fastened
nuts and bolts
High • Removing paint and lacquer
• Soldering plumbing joints
Attach the Correct Accessory (Fig. B)
This tool is supplied with a set of accessories for
different applications.
Icon Description
φ
20 Cone
nozzle
50 mm Fish tail
surface nozzle
1. Make sure the on/off switch
tool is disconnected from the power source. Ensure the
nozzle has cooled down.
2. Place the desired accessory onto the nozzle.
OPERATION

WARNING: Always observe the safety instructions
and applicable regulations.

WARNING: To reduce the risk of serious personal
injury, turn unit off and disconnect it from
power source before making any adjustments or
removing/installing attachments or accessories.
An accidental start-up can cause injury.

WARNING: Make sure the nozzle always points away
from you and any bystanders.

WARNING: DO NOT drop anything into the nozzle.

WARNING: Use only one hand to hold the tool as
shown in Figure C. Do not place your other hand over
the air vents.
Proper Hand Position (Fig. C)

WARNING: To reduce the risk of serious personal injury,
ALWAYS use proper hand position as shown.

WARNING: To reduce the risk of serious personal
injury, ALWAYS hold securely in anticipation of a
sudden reaction.
20
purpose
Welding, shrink sleeving
(heat concentrated over
small area)
Drying, thawing (heat
spread over wide area)
1 is in position "O" and the
Proper hand position requires one hand on the
main handle.
Fig. C
Prior to Operation (Fig. A)
1. Attach the correct accessory recommended for
the application.
2. Turn the air temperature adjustment knob/ LCD air
temperature indicator and adjuster
air temperature.
Switching On and Off (Fig. D)
1. Push the on/off switch 1
flow settings:
I:240 liter/min [122–752 °F (50 °C–400 °C)]
A low air flow to heat up the workpiece slowly.
II:450 liter/min [122–1112 ºF (50 °C–600 °C)]
A high air flow to heat up the workpiece quickly.
2. To turn the tool off, push the on/off switch
position O. Disconnect the tool from the power source
and let the tool cool down before moving or storing it.
Fig. D
1
Stripping Paint (Fig. A)

WARNING: Refer to Important Notice under
additional safety Instructions for heat guns
before using the tool remove paint.

WARNING: Do not strip metal window frames as the
heat may crack the glass.
• When striping other window frames, use the glass
protection nozzle.
4 to desired
to the desired air
1 to