Tabla de contenido
Idiomas disponibles
Idiomas disponibles
ENGLISH
ENG
7.3
Tool change with a geared chuck (1)
3x
Chucking the tool: Insert the tool and use the
chuck key to uniformly clamp tight all 3 bores.
Removing the tool: Open the geared chuck with
the chuck key and remove the tool.
8 Tips and Tricks
In the case of deep bores pull the drill bit out of the
bore from time to time in order to remove the bore
dust or shavings.
9 Trouble Shooting
If the trigger (4) can not be depressed, check to see
that the direction of rotation selector switch (3) is
fully set to the R or L position.
10 Maintenance
Motor cleaning: blow out the machine regularly and
thoroughly through the air slots with compressed
air.
11 Accessories
Use only genuine Metabo accessories.
If you need any accessories, check with your
dealer.
For dealers to select the correct accessory, they
need to know the exact model designation of your
power tool.
See page 4.
A Angle Drilling and Screwdriving Attachment
B Flexible Shaft
C Drill Stand
D Machine Vice
E Steel-wire End Brush
F Steel-wire Cup Brush
8
G Steel-wire Wheel Brush
H Fitting bit spring
For complete range of accessories, see
www.metabo.com or the main catalogue.
12 Repairs
Repairs to electrical tools must be carried out by
qualified electricians ONLY!
Any Metabo power tool in need of repair can be sent
to one of the addresses listed in the spare parts list.
Please enclose a description of the fault with the
power tool.
13 Environmental Protection
Metabo's packaging can be 100% recycled.
Scrap power tools and accessories contain large
amounts of valuable resources and plastics that can
be recycled.
These instructions are printed on chlorine-free
bleached paper.
14 Technical Specifications
Explanatory notes on the specifications on page 2.
Changes due to technological progress reserved.
P
=
Nominal power input
1
P
=
Power output
2
n
=
No load speed
0
n
=
Speed at rated load
1
ø max =
Max. solid drill diameter
b
=
Chuck capacity
G
=
Spindle thread
m
=
Weight without mains cable
D
=
spindle collar diameter
Wear ear protectors!
The technical s pecifications quoted are s ubject to
tolerances (in compliance with the relevant valid
s tandards ).
Tabla de contenido
