Troubleshooting: Causes And Remedies; Recommended Cutting Disks - IMER TERRA 450 Manual De Uso, Mantenimiento Y Recambios

GB
TROUBLE
The engine fails to start
Considerable reduction of blade speed or stop-
ping of it when cutting
The machine fails to move forwards
Lack of cooling water
CODE
1193917
1193921
1193918
1193920
IMER INTERNATIONAL S.p.A.

18 - TROUBLESHOOTING: causes and remedies

CAUSES
Belts slackened or broken
Blade not aligned with the assigned cutting
direction
Excessive cutting depth in relation to moving
speed
Blade unsuitable for the material to be cut
Worn blade
Empty tank
Faulty water supply
Clogged pipes or tap; tap closed
If the trouble persists contact the IMER Service Dept.

19- RECOMMENDED CUTTING DISKS

DISK DIAMETER
450 mm
500 mm
450 mm
500 mm
TERRA 450
HOLE DIAMETER
25,4 mm (1")
25,4 mm (1")
20
REMEDIES
See the engine handbook
Tension or change the belts
Check that the line-guide not been accidentally
folded, if so check to realign it to the disc or
replace it.
Cut in two passes or move forwards more
slowly
Replace the blade with a suitable one (see
RECOMMENDED DISKS table)
Replace the blade with a new one
Fill the tank
Check the supply
Clean the pipes and tap, making sure that it is
open
MATERIAL TO BE CUT
Old cement
Fresh cement
Asphalt