Removing The Bumper Bar; Adjusting The Seat Unit; Adjusting The Calf Support; Fitting/Removing The Seat Unit Hood - Kiddy evostar1 Manual De Uso

3.3. Removing the bumper bar

Press the small buttons on the seat unit under the bumper bar (fig. 16; no. 1) and
pull the bumper bar away from the seat unit (fig.16; no. 2).
Note: The bumper bar can be released one side at a time to allow easy access for
placing your child in or removing your child from the seat unit (fig. 17).

3.4. Adjusting the seat unit.

Lift the adjustment handle on the top side of the seat unit (fig. 18; no. 1) and
adjust the seat to the desired position (fig. 18; no. 2). The seat unit will lock into
position when the handle is released.
Note: The seat unit has 3 positions.

3.5. Adjusting the calf support.

Pull the calf support upwards to raise.
Depress both grey buttons at the side of the footrest (fig. 19; no. 1) to lower into
the desired position.
Note: The calf support has 4 positions (fig. 19; no. 2).

3.6. Fitting/removing the seat unit hood.

Attach and fasten the zip; push the plastic clips firmly onto the seat unit frame
then close the clips (fig. 20). To remove; unfasten the clips from the seat unit
frame and open the zip.

3.7. Using the 5 point safety harness.

Fit together the two connectors on the harness straps and push firmly into the
buckle housing until they click together (fig. 21).
Important: Ensure they are fully engaged before use.
As your child grows, the height of the shoulder straps can be altered. Reach inside
the seat back rest and locate the buckles. Thread through the opening in the seat
EN
18 18