WARNING
Carry out the described assembly and installation operations with great care.
Failure to follow these recommendations may result in damage to the machine
and put the operator's safety at risk.
WARNING
Keep the original packaging for future transport.
WARNING
The place where the machine is to be installed must conform to applicable safe-
ty at work regulations.
The machine must be installed on a stable and rigid fl oor in order to prevent it from
undergoing any structural deformation.
Position the machine so that it is accessible from all four sides. In particular check the
minimum working spaces shown in fi g.4.
IMPORTANT: for correct, safe use of the equipment, users must ensure a light-
ing level of at least 300 lux in the place of use.
ATTENTION
The machine must not be operated in potentially explosive atmosphere.
- Relative humidity: 30-95% without condensation
- Temperature: 0° ÷ +55°
GB
WARNING
All operation required for the electrical hook-up of the machine must be carried
out exclusively by a qualifi ed electrician.
- The electrical supply must be suitably sized in relation to:
• absorbed power specifi cation indicated on the machine dataplate.
• the distance between the machine and the power supply hook-up point, so that volt-
age drops under full load do not exceed 4% (10% in the case of start-up) below the
rated voltage specifi ed on the dataplate.
22
INSTALLATION
Place of installation
Working environment conditions
Electrical and pneumatic hook-ups
Operator's manual BL 600