Filtration Process; Requirements; Operation Notes; Starting The Filtration Process - VITO 30 Manual De Instrucciones

1. After the cycle time is displayed wait for the green LED (2) to flash (VITO 80 will beep additionally)
2. Set the beeper status using the push button (3)
3. The indicators show the selected status:
Red LED (1) = beeper off
Green LED (2) = half volume
Red LED + green LED = full volume (1) + (2)
Pull out the power cord (8).
The new settings are now saved.

8. Filtration process

8.1 Requirements

VITO 30 / 50 / 80
• Insert particle filter into the pump-filter unit (9) (See chapter 11 Particle filter change.)
• Latch filter-lid
• Put control unit (6) on pump-filter unit (9)
• Tighten the star handles (5).

8.2 Operation notes

• BEFORE START WORKING WITH VITO YOU MUST TURN OFF THE FRYER .
• Filtration cycle can be stopped at any time by pressing push button (3).
• Do NOT move VITO while filtration is in progress!
• Only use VITO in a straight position!
• The Power indicator (red LED) (1) and Filtration indicator (green LED) (2) are lit during
filtration process.

8.3 Starting the filtration process

1. Turn off the fryer.
2. Take VITO out of the drip pan (4)
3. Make sure that the particle filter is in the pump filter unit (9)
4. Put VITO into the fryer.
5. Ensure a secure standing (for holding brackets see chapter 12 Accessories)
6. Check the frying oil level
(The oil level must be between the MIN and MAX marking of the pump-filter unit (9)!)
7. Plug in VITO:
Power indicator (red LED) (1) is active
Cooling fan is running (VITO50 / VITO 80)
8. Press push button (3)
9. Filtration indicator (green LED) (2) is lit during the filtration.
8.4 Finish the process prematurely
1. Press push button (3)
Filtration indicator (green LED) (2) is off
2. Pull the power cord (8): VITO 30
Keep VITO 50 / VITO 80 plugged in!
3. Lift VITO, let oil flow back in the fryer
4. Place VITO in the drip pan (4)

9. Safety functions

9.1 Tilt and vibration protection (VITO 80 only)

If VITO 80 is tilted more than 15°, topples over or vibrates too strong because of bad placement or
mechanical defect, the machine will switch off. Both indicators start flashing and a repeating beep will
be heard.

9.2 Acoustic signal (VITO 80 only)

At the end of each cycle VITO 80 beeps for 5 seconds. VITO 80 will also beep if any error occurs.

9.3 Temperature control

If the temperature of the electrics is exceeded, VITO stops the filtration.
The power indicator (red LED) (1) starts to flash and VITO 80 starts to beep continuous.
Page 5