Tabla de contenido
Idiomas disponibles
Idiomas disponibles
Tools and Parts
Gather the required tools and parts before starting installation.
The parts supplied are in the washer drum.
Tools needed for connecting the water inlet hoses
Pliers (that open to 1
9
⁄
" [39.5 mm])
16
Tools needed for installation
A
B
C
A. Open end wrenches 1/2"
(13 mm) and 9/16" (14 mm)
B. TORX T20
security
®†
screwdriver
Parts supplied
A
D
E
A. U-shaped hose form
B. Water inlet hoses (2)
C. Inlet hose washers (4)
D. Transit bolt hole plug (4)
Location Requirements
Selecting the proper location for your washer improves
performance and minimizes noise and possible washer "walk."
Your washer can be installed under a custom counter, or in a
basement, laundry room, or recessed area. See "Drain System."
Companion appliance location requirements should also be
considered. Proper installation is your responsibility.
You will need
A water heater set to deliver 120°F (49°C) water to the washer.
■
A grounded electrical outlet located within 6 ft. (1.8 m) of
■
where the power cord is attached to the back of the washer.
See "Electrical Requirements."
Hot and cold water taps located within 4 ft. (1.2 m) of the hot
■
and cold water fill valves, and water pressure of 20–100 psi
(137.9–689.6 kPa).
†
TORX and T20 are registered trademarks of Acument Intellectual Properties, LLC.
®
4
INSTALLATION REQUIREMENTS
Flashlight (optional)
D
E
F
C. 1/4" (6 mm) Nut driver
D. Level
E. Wood block
F. Ruler or measuring tape
B
C
F
G
E. Beaded tie strap
F. Drain hose
G. Hose clamp
A level floor with a maximum slope of 1" (25 mm) under entire
■
washer. Installing the washer on soft floor surfaces, such as
carpets or surfaces with foam backing, is not recommended.
A sturdy and solid floor to support the washer with a total
■
weight (water and load) of 400 lbs (180 kg).
Do not operate your washer in temperatures below 32°F (0°C).
Some water can remain in the washer and can cause damage
in low temperatures.
Installation clearances
The location must be large enough to allow the washer door
■
to be fully opened.
Additional spacing should be considered for ease of
■
installation and servicing. The door opens more than 90,°
and it is not reversible.
Additional clearances might be required for wall, door,
■
and floor moldings.
Additional spacing of 1" (25 mm) on all sides of the washer
■
is recommended to reduce noise transfer.
Companion appliance spacing should also be considered.
■
Washer Dimensions
50 ½"
(1282 mm)
* Height without leveling feet installed.
Door is not reversible
Door is not reversible.
A floor drain should be provided under the bulkhead.
Prefabricated bulkheads with electrical outlets, water inlet lines,
and drain facilities should be used only where local codes permit.
27"
(686 mm)
*
44
/
"
5
8
(1134 mm)
28
/
"
13
16
(732 mm)
Tabla de contenido
