Tabla de contenido
Idiomas disponibles
Idiomas disponibles
NOTICE: During cutting, if the band saw becomes locked or jammed
in the workpiece material, release the switch immediately to avoid
damage to the band saw blade and motor.
FIG. 9
RECOMMENDED CUTTING POSITIONS
YES
NO
YES
NO
YES
NO
5. The tool's own weight provides the most efficient downward
6. End pieces, which would be heavy enough to cause injury when
YES
NO
7. Hold the saw firmly in both hands so that the saw does not fall
Tips for Better Cutting
The following recommendations should be used as a guide. Results
may vary with the operator and the particular material being cut.
• Never twist the band saw blade during cutting operation.
• Never use liquid coolants with portable band saws. Use of liquid
YES
NO
• If excessive vibration occurs during the cut, ensure that the
MAINTENANCE
tool off and remove battery pack before making any adjustments
or removing/installing attachments or accessories. An accidental
start-up can cause injury.
YES
NO
Lubrication
Self-lubricating bearings are used in the tool and periodic relubrication
is not required. In the unlikely event that service is ever needed, take
your tool to an authorized service location.
Cleaning
at least once a week. To minimize the risk of eye injury, always wear
ANSI Z87.1 approved eye protection when performing this.
15
cutting pressure. Added operator pressure slows the blade and
reduces blade life.
they drop, after cut-off, should be supported. Safety shoes are
strongly recommended. End pieces may be hot.
against clamped or supported material when the cut is completed.
coolants will cause build-up on tires and reduce performance.
material being cut is is securely clamped down. If vibration
continues, change the band saw blade.
WARNING: To reduce the risk of serious personal injury, turn
WARNING: Blow dirt and dust out of all air vents with clean, dry air
Tabla de contenido
