Inserting The Battery; Important; Measuring Distances - Powerfix Profi PMDL 5 B1 Instrucciones De Uso

Inserting the battery

1. Open the battery compartment
Detector.
2. Place the 9 V block battery onto the contacts. Pay heed to the correct
polarity.
3. Lay the tape for removal of the battery underneath the 9 V block battery
and press it into the battery compartment

Important!

Ensure that the wires are not trapped in any way.
This would lead to irreparable damage to the appliance.
4. Close the battery compartment
with an audible click.

Measuring distances

1. Slide the function switch
To switch between the metric and the Anglo-American units of measurement,
press and hold the button MODE
release both buttons simultaneously. When you release the buttons, the mea-
surement units change.
Note:
Measurements start at the measurement point
Should the measurement lie outside the measurement range, „Err" or an
illogical number appear in the display. The measurement range lies between
0,6 m (2') and 16 m (53').
2. Hold the appliance upright towards the wall to which you wish to measure
the distance. The ultrasound sender/receiver
to the wall. For this, use the spirit level: The bubble in the glass
stand between the marking lines (see Fig. 1).
3. Press the button READ
When you hold the button READ
appliance over the surface to be measured, the appliance continually
measures the distances. These are shown on the display
t
on the rear side of the Multi-Purpose
t
. The battery compartment lid must close
q
to „DISTANCE". The display
7
. Then press the button READ
6
. The distance measured appears in the display
6
pressed down and slowly move the
- 41 -
t
.
2
switches itself on.
1
!
0
must be at a right-angle
2
6
and
8
must
2
.
.