Functional Description Of The Command Transmission Unit - Tx Unit - SICE S 58 LL Manual De Instrucciones

9- Bead-breaker disc plane dead-man switch
10- Tool plane dead-man switch
11- Function reset button
12- Wheel diameter setting buttons. Button 12a decreases value, button 12b
increases value
13- Function button, pressed simultaneously with:
button 12a to store a tool position other than the default positions
button 12b to toggle between inches and millimetres
buttons 14/15 to execute side to side operation with tool unit rotation
14- Button for executing side to side operation without tool unit rotation to switch
from rear bead to front bead
15- Button for executing side to side operation without tool unit rotation to switch
from front bead to rear bead
16- Emergency button
FUNCTIONAL DESCRIPTION OF THE COMMAND
TRANSMISSION UNIT – TX UNIT –
TRANSMISSION MONITORING VIA THE LEDS
As a visual aid for the user, different coloured LEDs are located on the TX unit for
monitoring the transmission system.
The LEDs turn on at the same time for approx. 1 second when the TX unit switches
on for the self-test.
NB: the battery must be disconnected to turn off the TX unit. When the battery is
reconnected, the TX unit will turn on and perform the self-test.
TX UNIT LED: Fig.15
TX ON LED (GREEN)
"F" LED (RED)
STOP LED (RED)
LOW BATT LED (YELLOW)
FUNCTION OF THE GREEN TX ON LED:
When it is on this indicates that data is
being transmitted from the transmitting unit to the receiving unit following the acti-
vation of one or more commands.
It will remain on as long as the commands are activated.
FUNCTION OF THE RED "F" LED:
Not used.
FUNCTION OF THE YELLOW LOW BATT. LED
This LED turns on when the TX unit power supply battery voltage is below the mini-
mum operating threshold.
- E
- Operator's manual
nGlISH
15
69