Solenoid Valve Connection For Water Entry And Drainage; Coin Box Connection - Zummo Z10 Manual Del Usuario

 Outlet water pump.  Gsm modem. Provides information on the status of the machine via sms.
 Cup dispenser set ø73
 Cup dispenser set ø76
 Cup dispenser set ø78
 A connection kit can be fitted to provide a water inlet and outlet.
2.1. CONNECTION FOR WATER ENTRY AND DRAINAGE
WATER ENTRY
 You can connect your ZUMMO VENDING machine to an exterior drinking water source
by using a G ¾"-14 threaded tap.
 Carry out the following on the machine:
 Remove the upper cap positioned on the rear and screw the solenoid valve to the rear
of the machine using the two self-tapping screws supplied with your machine.
 Take the transparent hose that sucks the water from the container and connect it
directly to the solenoid valve, fastening it with the enclosed clamp. (Fig. 13)
 Disconnect the water pump connector located on the lower rear of the squeezing unit
and connect it to the solenoid valve. (Fig. 14 y 15)
 Position the rubber hose between the tap and the machine with its respective joints.
(Fig. 16)
 Test the machine by pressing button "S3" on the electronic plate. Water should come
out of the jets.
DRAINAGE
 ZUMMO VENDING has a discharge water pump pre-installation consisting of:
- An electric outlet (230 V or 110 V according to your ZUMMO VENDING machine
standard) located inside the wall wiring conduit beside the water entry.
- And an exit for a drainage discharge hose, located 30cm below water entry.
INNOVACIONES MECANICAS, S.A. does not supply neither the discharge water pump nor the
discharge water hose.
A standard discharge water pump and hose can be used (used in domestic washing machines).
Attention! Make sure that electricity supply of your discharge water pump coincide with the
electricity supply of your ZUMMO VENDING.
 The pump turns on and off automatically while the cleaning system is in use

2.2. COIN BOX CONNECTION

 The machine is prepared to work with EXECUTIVE or MDB Coin Operators:
ATTENTION: BEFORE CONNECTING OR DISCONNECTING THE COIN OPERATOR,
DISCONNECT ZUMMO VENDING BY USING THE GREEN SWITCH! (Scheme 1, No. 18)
- EXECUTIVE COIN OPERATORS: Connect the Coin Operator to the cable supplied with
the machine and connect this to the J2 connector on the control panel (Scheme 2, J2 and
Fig. 8). Program field No. 6 to "0"; see Section 7 of this manual.
- MDB COIN OPERATORS: Connect the Coin Operator to the J1B connector on the control
panel (Scheme 2, J1 and Fig. 9). Program field No. 6 to "1".
- Adjust the position of the amber coin slot operator part (Fig. 9A) so when you close the
payment door and you activate the amber coin slot operator, this part activates the top
lever of the coin box (Fig. 9B).
35