Toro EVOLUTION AG Manual Del Usuario página 27

Soil Sensor Setup
®
e EVOLUTION AG controller will stop the scheduled watering if the soil sensor is activated.
sensor, halting irrigation when it senses an excessive soil moisture level. You can set the level of soil moisture that will trigger the sensor.
e irrigation schedule will restart after the sensor dries out to the established threshold.
Step 1 – While in the ADVANCED menu, use the Up
Step 2 – Use the Up or Down
Step 3 – Use the Left or Right
Step 4 – Use the Up or Down
rain sensor is activated,
disable the sensor for that schedule.
SENSORS
A B
RAIN
WEATHER
SOIL 1
SOIL 2
Use the Right arrow or press SELECT
SENSORS
MOISTURE NOW
LOW THRESHOLD 50%
SIGNAL STRENGTH
BATTERY LEVEL GOOD
CALIBRATE START
CAL SETTING
FREEZE OFF AT 39
ID 34278
CURRENT TEMP 70
LOW THRESHOLD - Limit when watering is immediately adjusted.
SIGNAL STRENGTH - Displays the strength of the received signal from the soil sensor.
BATTERY LEVEL - Displays the soil sensor's battery level.
CALIBRATE - Activate to calibrate the soil sensor. Use the Right
Consult the soil sensor's user guide for calibration recommendations.
CAL SETTING - Set a number of times the controller will repeat the calibration and average the measurements.
FREEZE OFF AT - You can set the temperature when the controller will determine freezing and prevents scheduled watering
from operating. Use the Up
ID - Displays the identi cation number of the soil sensor device.
CURRENT TEMP - Displays the current measured soil temperature.
or Down
arrows to select SOIL, then press SELECT
arrows to select the schedule.
arrows to place a check mark under the desired schedules to assign the rain sensor. When the
®
EVOLUTION AG will prevent schedules from operating. Replace the check mark with a dash to
Ca
to access the soil sensor setup screen.
5
O F
O F
or Down arrows to adjust the temperature limit to determine the freezing point.
e Soil Sensor works much like a rain
arrows to select SENSORS, then press SELECT
.
arrow to navigate to START, then press SELECT
.
.
23