Battery Installation - Toro EVOLUTION AG Manual Del Usuario

Tabla de contenido
Idiomas disponibles

Idiomas disponibles

Module Removal
Step 1
– Open the
EVOLUTION
internal components.
– Hold the module as shown in Figure 11. Press the retaining tab while pulling
Step 2
the top of the module away from the cabinet, then lift the module out of
the controller.

Battery Installation

®
e
EVOLUTION
AG
controller uses a 9-VDC battery for arm-chair programming.
– Open the
EVOLUTION
Step 1
internal components.
Step 2
– Locate the battery compartment at the back of the control panel.
Step 3
– Align the polarity (– and +) of the battery then slide it into the battery
compartment as shown in Figure 12.
Note: You may need to pull the battery tab forward to align the battery properly.
®
AG
controller door and control panel to access the
®
AG
controller door and control panel to access the
Figure 11
Figure 12
+
5

Capítulos

Tabla de contenido
loading

Tabla de contenido