Tabla de contenido
Idiomas disponibles
Idiomas disponibles
ACCESSORIES
The following accessories are available to customize your SP100 Pump. Contact your Tuthill Representative if you have questions, or would like to
order any of the accessories listed below.
Part #
KITS10WMA
KITS10FRH
KITS05MUF
KITS10WCH
REGULATORY COMPLIANCE*
The Tuthill SP100 1" Air Operated Diaphragm Pump has been tested and complies to the rigid standards for certification by the following regulatory
agencies.*
Polypropylene (non-conductive) models comply with European standards:
2006/42/EC – Machinery
BS EN ISO 12100:2010, Safety of machinery – General principles for design – Risk assessment and risk reduction
BS EN 809:1998 – Pumps and pump units for liquids – Common safety requirements.
Models for use in ATmosphere EXplosive (ATEX) that comply with European standards:
94/9/EC - (until April 19th, 2016) and 2014/34/EU (after April 20th, 2016) - Directive on equipment intended for use in potentially
explosive environments.
EN 13463 - 1 - Non-electrical equipment for use in potentially explosive atmospheres: Part 1: Basic method and requirement.
EN 13463 - 5 - Non-electrical equipment for use in potentially explosive atmospheres: Part 5: Protection by constructional safety "c".
*
Refer to regulatory information printed on the top of the pump body for specific pump compliance.
Learn more about Tuthill Corporation and our family of high quality, value minded products at:
Accessory
Wall Mount Bracket
Filter / Regulator Kit
Muffler
Assembly Wrench
www.tuthill.com
12
Description
Steel bracket for wall mount applications of the SP100 Air
Operated Diaphragm Pump.
Air line filter, regulator, and hose
Muffler for air exhaust
Special service tool for use on fluid cap rings (13A in
diagram on page 8).
Tuthill Corporation
8825 Aviation Drive
Fort Wayne, IN
46809 1-800-634-2695
1-260-747-7524
DC000967-001 Rev.5
Tabla de contenido
