Adjusting The Air Flow Direction - Technibel Climatisation MCW1B5XA Instrucciones De Uso

ADJUSTING THE AIR FLOW DIRECTION

HORIZONTAL (manual)
The horizontal air flow can be adjusted by moving the
vertical vanes to the left or right, as indicated in the following
figures.
MCW MODELS
Left
Vertical vane
KPSW MODELS
VERTICAL VANE
VERTICAL (with remote control unit)
The remote control gives you the possibility to control the
flap in two way:
1. Push the button to start the flap sweep. If you
push again the flap stops immediately.
2. Push the button to move the flap step by step.
CAUTION
Set vertical vanes to the front position during
COOLING/DRY operation if humidity is high.
If the vertical vanes are set to the left-most or right-most
position, condensation will form around the air outlet
and drip off.
• The flap automatically closes when the unit is off.
NOTES
• During the heating operation, the fan speed
will be very low and the flap will be in the
horizontal position until the air being blown
out of the unit begins to warm. Once the air
warms up, the flap position and fan speed
change to the settings specified with the
remote control.
CAUTION
Do not move the flap with your hands when the air
conditioner is running.
Right
Sweep function
The flap starts
moving up and
down to deliver air
over the sweep
range.
(ONLY MCW- KPSW)
CAUTION
• Use the FLAP button on the remote control to adjust
the position of the flap. If you move the flap by hand,
the factual flap position and the flap position on the
remote control may no longer match. If this should
happen, shut off the unit, wait for the flap to close,
and then turn on the unit again; the flap position will
now be normal again.
• Do not have the flap pointed down during cooling
operation. Condensation may begin to form around the
air vent and drip down.
MCW MODELS
Down
Flap
Air outlet
grille
KPSW MODELS
HOW TO ADJUST THE FLAP DIRECTION
« A »
« B »
Zone «A»
for cooling and dehumidifyng
CWX MODELS
FLAPS
8
Up
FLAP
« A »
« B »
40°
Zone «B»
for heating
GB