Marsh Touch Taper 4BT Serie Manual Del Propietário página 14

Operation
Adjusting the Water
Level in the Brush
Tank
Figure E
Figura E
25005/97231 Rev D
The water regulator hangs on a screw located on the left side of the machine. The water
level in the brush tank is adjusted by moving this screw up or down in its bushing. See
Figure E.
Increase Water Level
Hausse du niveau d'eau
Subir nivel de agua
Decrease Water Level
Abaissement du niveau d'eau
Bajar nivel de agua
To increase the water level in the brush tank:
1. Loosen the screw and slide the regulator up in its slot.
2. Tighten the screw when you have repositioned the regulator so that the water level
in the brush tank has risen to the correct level.
To decrease the water level in the brush tank:
1. Loosen the screw and slide the regulator down in its slot.
2. Tighten the screw when you have repositioned the regulator so that the water level
is lowered to the correct level.
Screw
Vis
Tornillo
Water Regulator
Régulateur d'eau
Regulador de agua
13