Tabla de contenido
Idiomas disponibles
Idiomas disponibles
42
EN
Before requesting service for a problem, use this chart and see if you can repair the trouble yourself. Small problems are often easily
corrected, and this can save you the trouble of sending your VCR off for repair.
POWER
SYMPTOM
1. The power won't come on.
2. The clock works, but the VCR's
power won't come on.
3. The remote control won't function.
TAPE TRANSPORT
SYMPTOM
1. The cassette gets stuck partway
during loading, and is ejected.
PLAYBACK
SYMPTOM
1. The tape is running but the picture
won't appear.
2. Noise appears during visual search.
3. Breaks are noticeable in Hi-Fi
soundtrack.
4. The playback picture is blurred or
interrupted, even though TV
broadcasts are clear.
5. The Hi-Fi soundtrack cannot be
heard.
RECORDING
SYMPTOM
1. Recording won't start.
2. TV broadcasts won't record
properly.
3. Tape-to-tape editing won't work.
POSSIBLE CAUSE
The power cord is disconnected.
The TIMER mode is engaged with
Auto Timer set to "OFF" (
The batteries are discharged.
The VCR/TV/CABLE/DBS switch is
in the wrong position.
POSSIBLE CAUSE
The cassette was inserted incorrectly.
POSSIBLE CAUSE
If you're using the RF OUT connec-
tion (
pg. 4), the channel selector
on the TV is set incorrectly.
If you're using the AV connection
(
pg. 4), the TV receiver is set to
the wrong mode.
This is normal.
Automatic tracking is engaged.
The video heads may be dirty.
The AUDIO MONITOR option was
set incorrectly.
POSSIBLE CAUSE
There's no cassette loaded.
The loaded cassette has had its
record safety tab removed.
The VCR has been set to its AUX
mode by mistake.
The VCRs or the camcorder and the
VCR have been incorrectly con-
nected.
The power to one or more of the
units has not been turned on.
The recorder's input mode has been
set incorrectly.
TROUBLESHOOTING
CORRECTIVE ACTION
Connect the power cord.
Press TIMER to disengage.
pg. 33).
Replace the dead batteries with new
ones.
Set the switch to the position
corresponding with the unit you want
to operate.
CORRECTIVE ACTION
Make sure the cassette's window is
facing up, the rear label side is facing
you and the arrow on the front of the
cassette is pointing towards the VCR.
Then insert the cassette.
CORRECTIVE ACTION
Set the channel selector to channel 3
or 4.
Set the TV receiver to its AV mode.
Disengage Auto Tracking and adjust
the tracking manually (
The heads must be cleaned. Consult
your JVC dealer.
Set AUDIO MONITOR to "HI-FI"
(
pg. 20).
CORRECTIVE ACTION
Insert a cassette.
Remove the cassette and cover the
hole with adhesive tape, or load a
cassette on which the record safety
tab is intact.
Set the VCR to the appropriate
channel.
Refer to the directions and the
illustration under "Edit To Or From
Another VCR" (
From A Camcorder" (
properly connect the units.
Make sure the power to all units is on.
Select the recorder's appropriate
input mode.
pg. 16).
pg. 35) or "Edit
pg. 36) and
Capítulos
Tabla de contenido
