Preparation; Remote Control Unit; Main Unit; Cancellation Of Demonstration - Panasonic CQ-C3433U Manual De Instrucciones

Preparation

Preparation Before Initial Use
Pull the insulation film out from the
backside of the remote control gently.
Battery Replacement
q Remove the battery holder with the
remote control unit placed on a flat
surface.
q Stick your thumbnail into the
groove and push the holder in the
direction of the arrow at the same
time.
w Pull it out in the direction of the
arrow using a tough pointed object.
w Put a battery in the case with (+) side
facing up.
e Put the case back.

Cancellation of Demonstration

The demonstration message appears for initial
use.
q Set your car's ignition switch to the ACC or ON position.
The demonstration screen appears.
w Press [SRC/PWR] to turn on the power.
e Press and hold [VOLUME] (PUSH SEL) for more
than 2 seconds to open the menu.
r Press [VOLUME] (PUSH SEL) to select the
Demonstration setting. ("DEMO" is displayed.)
t Turn [VOLUME] counterclockwise. (Press [0] (
the remote control unit.)
Note:
¡ To return to the regular mode, press [D] (DISP).
¡ Refer to the section on "Function Settings".
(a Page 22)
[SRC/PWR] (Power)
[VOLUME]
(PUSH SEL: select)

Remote Control Unit

Tough pointed
object
Back side

Main Unit

) on
{
[D] (DISP/CLOCK)
[]] [[]
(Hour/minute adjustment)
CQ-C3433U/C3403U/C3333U/C3303U
Warning
¡Keep a battery away from children to avoid the risk of
accidents. If an infant ingests a battery, please seek immediate medical attention.
Caution
¡Remove and dispose of an old battery immediately.
¡Do not disassemble, heat or short a battery. Do not
throw a battery into a fire or water.
¡Follow local regulations when disposing of a battery.
¡Improper use of a battery may cause overheating, an
explosion or ignition, resulting in injury or a fire.
Note:
¡Battery Information:
Battery Type: Panasonic lithium battery (CR2025)
(Included in the remote control)
Battery Life: Approximately 6 months under normal use
(at room temperature)

Clock Setting

The 12-hour system is used for the clock.
q Press [SRC/PWR] to turn on the power.
w Press [D] (DISP/CLOCK).
Clock display
e Press and hold [D] (DISP/CLOCK) for more than 2
seconds.
Hour blinks
r Adjust the hour.
[[]: put forward hour.
[]]: put back hour.
Hour entered
t Press [D] (DISP/CLOCK).
Minute blinks
y Adjust the minute.
[[]: put forward minute.
[]]: put back minute.
Minute entered
u Press [D] (DISP/CLOCK).
Completed
Note:
¡"ADJUST" is displayed before adjusting the clock.
¡Press and hold [[] or []] to change numbers rapidly.
E
N
G
L
I
S
H
8
9