This manual consists of two parts; the first part
contains safety precautions and descriptions of the
procedures when installing the SpaLet, and the
second part contains visual installation methods.
Please use this manual in reference to each part.
SAFETY PRECAUTIONS
For safe installation and use of the product,
please read the precautions thoroughly
before installing the product.
An imminently hazardous situation
DANGER
which, if not avoided, will result in death
or serious injury
A potentially hazardous situation which,
WARNING
if not avoided, could result in death or
serious injury.
A potentially hazardous situation which,
if not avoided, may result in minor or
CAUTION
moderate injury or damage to the
product or other property.
DANGER
Improper connection of the power plug or
socket can result in a risk of electric shock.
All electrical installation work must be carried
out by a qualified electrician.
There is a danger of short circuit and/or
electric shock.
WARNING
Follow the instructions described in this
manual, and install the product properly.
Failure to do so may cause electric shock, fire,
injury, water leakage, and/or flooding.
Do not allow anyone except a certified
electrician to disassemble, repair, or modify
the product.
There is a danger of electric shock or fire, and
the product could malfunction, causing injury.
Do not connect or disconnect the power plug
or socket or power cord with wet hands.
There is a danger of electric shock.
Hold the plug or socket when connecting
or disconnecting the power plug or socket.
If the plug or socket is connected or
disconnected by holding the cord, there is
a danger of fire or electric shock due to the
plug or socket or cord becoming damaged.
Do not pour water or the cleanser inside or
onto the SpaLet seat unit, remote
control, or power plug or socket.
It may cause electric shock or fire.
Do not use any power supply other than
AC120V. Also, do not use any other
method to connect the plug or socket to an
improperly configured receptacle,
exceeding the rated voltage for use.
Be sure to use a VVF cable (with solid
copper wires 20 AWG each) for the power
cord. If a power cord other than the one
specified above is used (such as
strand wires, strand wires attached
with terminals, etc.), it may result in
overheating due to bad connection and
cause corrosion, burnout, fire of the prod-
uct and cord.
Connect the power completely. There is a
danger of fire or electric shock due to the
cord becoming damaged.
Do not damage, bend, modify,
excessively twist, bind, sandwich, or
place heavy objects on the power cord.
There is a danger of fire or electric shock
due to the cord becoming damaged.
Do not install this product in a wet or
damp location, such as inside a shower
room or steam room.
There is a danger of electric shock or fire.
-2 EN-