High Altitude Operation - Homelite UT80432 Serie Manual Del Operador

Ocultar thumbs

Contenido

Tabla de contenido

Idiomas disponibles

 Remove the cap from the detergent tank and pour pres-

sure washer detergent in the tank. Replace cap on tank.

NOTE: The machine setting of this unit is 20:1, which usu-

ally allows the use of 1 gallon pressure washer detergent

without further dilution. Check your detergent instructions

to be sure additional dilution is not necessary.

 Install 5-in-1 Change Over Nozzle (if necessary). Rotate

the spray selector on the nozzle to either the blue short

range detergent ( ) or blue long range detergent ( )

setting.

 Squeeze the trigger and wait approximately 5 seconds

for the detergent to appear.

 Spray the detergent on a dry surface using long, even,

overlapping strokes. To prevent streaking, do not allow

detergent to dry on the surface.

For long range detergent application:

With the nozzle installed on the spray wand and the engine

shut off, rotate the spray selector to the long range detergent

[ ] setting.

For short range detergent application:

With the nozzle installed on the spray wand and the engine

shut off, rotate the spray selector to the short range deter-

gent [ ] setting.

Before shutting off the engine:

 Fill the detergent tank with clean water.

 Spray the clear water through the spray wand until the

tank is empty.

 If any soap remains in the spray, repeat with a second

tank of clean water.

 Shut off the engine.

NOTE: Shutting OFF ( O ) the engine WILL NOT relieve pres-

sure in the system. Pull trigger to release water pressure.

OPERATION

RINSING WITH THE PRESSURE WASHER

 Turn off the pressure washer and shut off the water

supply. Pull trigger to release water pressure.

 Engage the lock out on the trigger handle by pushing up

on the lock out until it clicks into the slot.

 Select the right nozzle setting for the job. See the chart

on the previous page for selecting the appropriate nozzle

setting.

 When using these settings, test a small area first to avoid

surface damage.

 Start at the top of the area to be rinsed and work down,

overlapping the strokes.

MOVING THE PRESSURE WASHER

See Figure 20.

NOTE: Never lift or carry this product using the handle and

never place the unit in any position other than upright on

its wheels.

 Turn the pressure washer off and ensure the fuel valve is

closed.

 Pull the handle up until the handle release knob snaps into

the locking position (if not already up and locked). Ensure

the lock is secured in the frame hole before moving.

 Tilt the machine toward you slightly until it balances on

the wheels then roll the machine to the desired position.

Do not tilt forward or sideways when moving.

 DO NOT attempt to move the unit by pulling on any of

the hoses.