Operation - Homelite HL80833 Manual Del Operador

wARNiNg:
Do not allow familiarity with the product to make you care-
less. Remember that a careless fraction of a second is
sufficient to inflict serious injury.
wARNiNg:
Always wear eye protection with side shields marked to
comply with ANSI z87.1. Failure to do so could result in
objects being thrown into your eyes resulting in possible
serious injury.
wARNiNg:
Do not use any attachments or accessories not recom-
mended by the manufacturer of this product. The use of
attachments or accessories not recommended can result
in serious personal injury.
wARNiNg:
Never direct a water stream toward people or pets, or
any electrical device. Failure to heed this warning could
result in serious injury.
APPLicATiONS
You may use this product for the purposes listed below:
 Using surface cleaner: removing dirt and mold from
decks and cement patios
 Using spray wand: cleaning boats, motorcycles, outdoor
furniture, grills, and house siding
AddiNg LUBRicANT TO ThE ENgiNE
See Figure 15.
NOTE: This machine has been shipped with approximately
2 oz. of lubricant in the engine from testing. you must add
lubricant to the engine before starting it the first time.
cAUTiON:
Any attempt to start the engine without adding lubricant
will result in engine failure not covered under warranty.
 Place pressure washer on a flat, level surface.
 Unscrew the oil cap / dipstick by turning counter-
clockwise.
 Using 4-stroke engine lubricant (SAE 10W30), add
engine oil until the fluid level rises to the upper fill level on
the dipstick (18 oz., 4-cycle engine lubricant provided).
do not overfill.
 Replace the oil cap / dipstick and securely tighten.
NOTE: This engine has a total lubricant capacity of 20 oz.
(.6 liters).

OPERATiON

OXygENATEd FUELS
dO NOT USE E85 FUEL. iT wiLL vOid yOUR wAR-
RANTy.
NOTE: Fuel system damage or performance problems re-
sulting from the use of an oxygenated fuel containing more
than the percentages of oxygenates stated below are not
covered under warranty.
Ethanol. Gasoline containing up to 10% ethanol by volume
(commonly referred to as E10) or 15% ethanol by volume
(commonly referred to as E15) are acceptable. E85 is not.
AddiNg gASOLiNE TO ThE FUEL TANK
See Figure 16.
wARNiNg:
Always shut off engine before fueling. Never add fuel to
a machine with a running or hot engine. Move at least
30 ft. from refueling site before starting engine. Do not
smoke! Failure to heed this warning could result in seri-
ous personal injury.
When adding gas to the pressure washer, make sure the unit
is sitting on a flat, level surface. If the engine is hot, let the
pressure washer cool before adding gas. ALWAYS fill the
fuel tank outdoors with the machine turned off.
NOTE: Use unleaded gas only. DO NOT mix lubricant with
gas.
 Before removing the fuel cap, clean the area around it.
Remove the fuel cap.
 Insert a clean funnel into the fuel tank then slowly
pour gasoline into the tank. Fill tank to approximately
1-1/2 in. below the top of the tank neck (this allows for
fuel expansion).
 Replace fuel cap and tighten until the cap "clicks."
 Clean up any spills before starting the engine.
STARTiNg ANd STOPPiNg ThE PRESSURE
wAShER
See Figures 17 - 18.
cAUTiON:
Do not run the pump without the water supply connected
and turned on.
Before starting the engine:
 Connect all hoses.
 Check all fluids (lubricant and gas).
 Turn on the garden hose then squeeze the trigger to
relieve air pressure; hold the trigger until a steady stream
of water appears.
10 — English