Tabla de contenido
Idiomas disponibles
Idiomas disponibles
IMPORTANT
NOTE TO INSTALLER
Please read the following
instructions
carefully before installing your Washer.
These instructions
should
be retained
for future reference.
We recommend
you hire a professional
for installation
of this washer.
STEP 1
Removing the Shipping
Bolts
Before using your Washer, you must remove the four shipping
bolts from the back of the unit.
t.
Loosen
all the bolts with the supplied
wrench.
2.
Slide the bolt and spacer up and remove the bolt with the
spacer through the hole in the rear wall of your washer.
Repeat for each bolt.
3.
Fill the holes with the supplied
Bolt Hole Covers (See page 7).
4.
Keep the shipping
bolts and spacers
for future use.
STEP 2
Selecting a Location
[_
Before you install your washer,
make sure the location:
Has a hard, level surface
Is away from direct sunlight
Has adequate
ventilation
Will not freeze (below 32°F or 0°C)
Is away from heat sources
such as oil or gas
Has enough slack for the power
cord.
Doesn't
have any carpeting
that will obstruct
ventilation
openings.
STEP 3
Installing your Washer
t.
Place the drain hose in the drain facility. Be
sure an airtight connection
is NOT made
between
the drain hose and the standpipe.
The standpipe
must be at least 18 in or 46
cm high.
(_
aution must always be exercised
to
avoid collapsing
or damaging
the drain
hose. For best results, the drain hose
should
not be restricted
in any way - by
elbows,
couplings,
or excessive
lengths.
For situations
where the drain hose
cannot
be conveniently
elevated
to at
least 18 in or 46 cm, the drain hose must
be supported.
Laundry tub
Stand pipe
HOW
96"Ma×
i ii:iI
le" MIn
TI _p
Installing
your washer
11
Capítulos
Tabla de contenido
