Tabla de contenido
Idiomas disponibles
Idiomas disponibles
na VOLAr w her
J
2.
Check the inlet hose to ensure a washer
is inside each fill
hose.
Cold
Thread the inlet hoses to the HOT and COLD faucet
connections.
On the other end of the hose, check for one rubber washer
per hose and install each fill hose to the water valve. Make
sure the hose with the Hot printed
line is attached
to the
HOT faucet. Tighten
by hand until snug, then two-thirds
of a
turn with pliers.
For correct
water use, connect
both HOT and COLD water
valves. If either or both are not connected,
an "nF" (no fill)
error can occur.
Oold printed
3. Turn on the "HOT" and "COLD "water supply and check all
connections
at the water valve and the faucet
for leaks.
Hot
4.
Plug the power
cord into a 3-Prong,
well grounded
120
volt 60 Hz approved
electrical
outlet protected
by a 15-
amp fuse or comparable
circuit breaker.
Your washer
is grounded
through
the third prong of the
power cord when plugged
into a three-prong
grounded
receptacle.
5.
Slide your washer
into position.
6.
Level your washer
by turning the leveling legs in or out as
necessary
by hand or by using the wrench
included
with
your washer.
When your washer
is level, tighten the locking
nuts using
the wrench
or (-) flathead
screwdriver.
[_
Your Washer must be leveled on all four sides. A
carpenter's
level should
be used on all four corners
of
your Washer.
It's a good idea after the first dozen washes
to recheck your washer's
levelness.
(_
Avoid damage
to the legs. Do not move
the Washer
unless the Locking-nuts
are
fastened
to the bottom
of the Washer.
i!!!!i!ii!!i
¸ll;i_i_;;ii_l%!i!i!llili!!i!i!i!_iill_lililililill_l_iiiililii_ilil!lili
12 Installing
your washer
Capítulos
Tabla de contenido
