Teuco Evolution E01 M Instrucciones De Montaje página 29

ADJUSTING THE DOOR
10
- If the door is not correctly aligned with the side panels, make the
necessary adjustment by way of the top grip assembly (1).
Having adjusted the door, fit the "doorstop" assembly (2) to the top
track with nuts and washers.
FITTING THE ROOF
11
- Position the roof on the top track, making certain that the hoses
and electrical cables drop behind the back panel.
- E01 M - E01 M CR -
12
- Hot water connection.
- Cold water connection.
5 - Showerhead connection.
E01 L - E01 L CR -
-
- Hot water connection.
- Cold water connection.
1,2 - Descaler liquid connections.
3 - Sauna drain connection.
4,6 - Vaporizer connections.
5 - Showerhead connection.
7,8 - Upper and lower jet connections.
9 - Hand-held shower connection.
10 - Cold water connection.
11 - Mixed water connection.
12 - Emergency valve connection.
E01 L - E01 L CR -
-
- Cable for connection to a.c. supply.
T - Cable for connection to alarm system
(only if bathroom is equipped with alarm system).
Aux - Audio input cable.
2 - Control panel connection.
4 - Connection of cable running from roof to power unit.
6 - Connection between power unit and temperature sensor.
12 - Connection of cable running from power unit to roof.
V - Connections between power unit and fans.
- EQUIPOTENTIAL EARTH CONNECTION
Connect the earth wire from the roof to the top binding post
( ) and wire this post to the main earth node for the
bathroom; connect the earth wire from the back panel to the
bottom post (
CHECKING THE PLUMBING AND ELECTRICAL
CONNECTIONS
Having made all the connections, start up the system as
described in the accompanying user manual.
Check that there are no leaks at the fittings and that everything
works as it should.
Plumbing connections
Plumbing connections
Electrical connections
).
SECURING THE BACK PANEL
13
- Secure the back panel to the shower base and to the top track
with the clamp parts removed previously. Snap the concealers onto
the screws.
FITTING THE ACCESSORY RAILS
-
14
Fit the accessory rails, locating the ends on the pins of the
shower base and in the holes at the top of the two side
panels.
Secure the tops of the rails to the wall bracket with nuts
and washers.
If the rails do not coincide with the plates fitted to the
wall bracket, make the necessary adjustments as in figures
14A and 14B.
FITTING THE WALL TRIMS
-
15
Prepare the wall trims, loosening the bolts (1).
A
Lift the fixing plates (2).
-
15
Hook the bottom ends (1) of the trims over the pins of the
B
shower base, and secure the top ends (2) to the wall
bracket with the screws and washers.
-
15
Tighten the bolts loosened previously.
C
SEALANT
-
16 Apply NEUTRAL SILICONE (NON-ACETIC) along the join
between the shower base and the floor so that water
cannot get in.
29