Assembly Instructions - Troy-Bilt TB4BP EC Manual Del Operador

ASSEMBLING THE BLOWER TUBE
WARNING:
To avoid serious personal injury and
damage to the unit, shut the unit off before removing or
installing the blower tube.
Installing the Flex Tube
1. Place a hose clamp over the end of the Flex Tube (Fig. 1A).
2.
Slide the end of the Flex Tube with the clamp on it over the
elbow tube (Fig. 1B).
3. Align the bump on the Flex Tube with the bump on the elbow
tube (Fig. 1C).
4. Tighten the screw on the hose clamp to secure the Flex Tube
to the elbow tube (Fig. 1D).
B
A
Installing the Upper Blower Tube
1. Place a hose clamp over the other end of the Flex Tube (Fig. 2, A).
2. Slide the end of the hose with the clamp on it over the top end
of the upper blower tube (Fig. 2, B).
3. Align the bump on the Flex Tube with the bump on the upper
blower tube (Fig. 2, C).
4. Tighten the screw on the hose clamp to secure the Flex Tube to
the upper blower tube (Fig. 2, D).
A
B
6

ASSEMBLY INSTRUCTIONS

D
Fig. 1
D
Fig. 2
Installing the Lower Blower Tube and Nozzle
1. Align the bump slot on the end of the lower blower tube with the
bump on the bottom end of the upper blower tube (Fig. 3, A).
2. Insert the bump on the upper blower tube into the bump slot on
the lower blower tube (Fig. 3, A).
3. Twist the lower blower tube clockwise around the upper blower
tube until the upper blower tube bump locks into place (Fig. 3, B).
A
C
4. Align the bump slot on the top end of the nozzle with the bump
on the bottom end of the lower blower tube (Fig. 4, A).
5. Insert the bump on the lower blower tube into the bump slot on
the nozzle (Fig. 4, A).
6. Twist the nozzle clockwise around the lower blower tube until the
nozzle bump locks into place (Fig. 4, B).
A
Secure the Throttle Cables
Place a zip tie around the elbow tube and the throttle cables, as shown
(Fig. 5). Tighten the zip tie, making sure not to crimp the cables.
Elbow Tube
C
Cables
Fig. 3
Fig. 4
Zip Tie
Fig. 5
B
B