Black and Decker LHT2220 Manual De Instrucciones página 5

Ocultar thumbs Ver también para LHT2220:
Tabla de contenido
Idiomas disponibles

Idiomas disponibles

SAVE THESE I NSTRUCTIONS:
This manual contains important
safety i nstructions
forbattery chargers.
• Before u singcharger,
read allinstructions
and cautionary markings
oncharger,battery
pack, and product using battery pack.
z_WARNING:
Shock hazard. Do not allow any liquid to get
inside charger.
i_CAUTION:
Burn hazard. To reduce the risk of injury, charge
only designated Black & Decker batteries. Other types of batteries
may burst causing personal injury and damage.
/_CAUTION:
Under certain conditions, with the charger plugged
in to the power supply, the charger can be shorted by foreign
material. Foreign materials of a conductive nature such as, but not
limited to, steel wool, aluminum foil, or any buildup of metallic
particles should be kept away from charger cavities. Always unplug
the charger from the power supply when there is no battery pack in
the cavity. Unplug charger before attempting to clean.
z_WARNING:
• The charger supplied
with this product is intended to be
plugged in such that it is correctly
orientated
in a vertical
or
floor mount position.
• DO NOT attempt to charge the battery pack with any chargers
other than the ones in this manual.
The charger and battery
pack are specifically designed to work together.
• These chargers
are not intended for any uses other than
charging designated
Black & Decker rechargeable
batteries.
Any other uses may result in risk of fire, electric shock or
electrocution.
• Do not expose charger
to rain or snow.
• Pull by plug rather than cord when disconnecting
charger.
This will reduce risk of damage to electric plug and cord.
o
o
Make sure that cord is located so that it will not be stepped on,
tripped
over, or otherwise
subjected
to damage or stress.
Do not use an extension
cord unless it is absolutely
necessary.
Use of improper extension cord could result in risk of fire, electric
shock; or electrocution.
An extension
cord must have adequate
wire size (AWG or
American
Wire Gauge) for safety.
The smaller the gauge number
of the wire, the greater the capacity of the cable, that is 16 gauge
has more capacity than 18 gauge. When using more than one
extension to make up the total length, be sure each individual
extension contains at least the minimum wire size.
Recommended
Minimum Wire Size for Extension Cords
Minimum
Gauge for Cord Sets
Volts
Total Length of Cord in Feet
120V
0-25
26-50
51-100
101-150
240V
0-50
51-100
101-200
201-300
Ampere
Rating
More Not more
American Wire Gauge
Than Than
0
6
18
16
16
14
6
10
18
16
14
12
10
-
12
16
16
14
12
12
-
16
14
12
Not Recommended
• Do not place any object on top of charger or place the charger
on a soft surface that might block the ventilation
slots and
result in excessive
internal heat. Place the charger in a position
away from any heat source.
The charger is ventilated through
slots in the top and the bottom of the housing.
• Do not mount charger on wall or permanently
affix charger to
any surface.
The charger is intended to use on a flat, stable surface
(i.e., table top, bench top).
• Do not operate charger
with damaged
cord or plug -- have
them replaced immediately.
• Do not operate charger
if it has received
a sharp blow, been
dropped,
or otherwise
damaged
in any way. Take it to an
authorized service center.
• Do not disassemble
charger;
take it to an authorized service
Tabla de contenido
loading

Este manual también es adecuado para:

Chh2220

Tabla de contenido