Declaration Of Conformity - Würth MSF 30 Instrucciones De Servicio

página de 105

/ 105
Contenido
Tabla de contenido

Tabla de contenido

Idiomas disponibles

Electronic overload protection

In case of a brief, very high overload on the product, the

integrated electronic overload protection will limit the

current consumption and in this way prevent excessive

heating of the motor.

If, when working with the product, the speed drops

significantly or the diamond cutting discs stop due to an

overload, leave the machine to run for a short time at

no-load.

In case of an extended overload, the light emitting

diode 6 will illuminate. Leave the product to run at no-

load until the motor has cooled to its normal operating

temperature and the light emitting diode 6 goes out.

Restart protection

If the plug is connected to the mains with the product

switched on or the supply of power is re-established

after a power failure, the product will not start. The

light emitting diode 6 flashes and the product must be

switched off and on.

Maintenance and care

q Unplug from the mains before all work on the

product.

Always keep product and ventilation slots

clean.

To prevent dust building up inside the product, the motor

must be blown out after extended use of the product

(through the ventilation slots on the rear end of the motor

housing). This task should not be undertaken indoors if

possible.

Should, despite careful manufacturing procedures and

test procedures, the product fail at some point, have

the product repaired by an authorised customer service

centre for WÜRTH electrical tools.

It is imperative you state the article number (see type

plate) of the product with all queries and orders for

spare parts..

Spare parts

It is only allowed to use original spare parts. The use of

other parts can cause damage to the product.

Protecting the environment

Recycling instead of refuse disposal.

Products, accessories and packaging

that are no longer useable should be

sent for recycling.

We reserve the right to make changes without notice

Only in EU countries:

Do not throw electrical tools in household waste. In

accordance with European directive 2002/96/EC

on waste electrical and electronic equipment and its

implementation in national law, used electrical tools

must be collected separately and recycled.

Warranty

For this WÜRTH product we provide a warranty as per

legal / national stipulations from the date of purchase

(proof of purchase with invoice or delivery note).

Resulting damage will be rectified by replacement or

repair. Damage due to improper handling is excluded

from the warranty.

Complaints can only be accepted if the product is

returned, without dismantling, to a WÜRTH subsidiary,

your WÜRTH sales representative or a service centre for

electrical tools authorised by WÜRTH.