Ec Declaration Of Conformity; Noise/Vibration Information - Würth 5707 011 Serie Instrucciones De Servicio

EC-Declaration of Conformity
We declare under our sole responsibility that the product
described under "Tool Specifications" complies with all appli-
cable provisions of the directives 2011/65/EU,
until 19 April 2016: 2004/108/EC, from 20 April 2016:
2014/30/EU, 2006/42/EC including their amendments
and is in conformity with the following standards:
EN 60745-1, EN 60745-2-3.
Technical file (2006/42/EC) at:
Adolf Würth GmbH & Co. KG, Abt. PCM
Reinhold-Würth-Straße 12–17
74653 Künzelsau
GERMANY
www.wuerth.com
Marcel Strobel
General Manager
Künzelsau: 02.07.2015
The following table indicates the action objectives for mounting and operation of the power tool. The instructions for each action
objective are shown aside. Depending on the type of application, various instruction combinations are required. Observe the
safety instructions.
Action
Grinding, preparation
Cutting, preparation
Cutting stone, brick and tiles,
preparation (recommendation)
Dr.-Ing. Siegfried Beichter
General Manager
Mounting and Operation

Noise/Vibration Information

The measured values of the machine are listed in the table on
page 254.
Sound emission values determined according to
EN 60745-2-3.
Vibration total values a
h
determined according to EN 60745-2-3.
The vibration level given in this information sheet has been
measured in accordance with a standardised test given in
EN 60745 and may be used to compare one tool with
another. It may be used for a preliminary assessment of expo-
sure.
The declared vibration emission level represents the main
applications of the tool. However if the tool is used for differ-
ent applications, with different accessories or insertion tools or
is poorly maintained, the vibration emission may differ. This
may significantly increase the exposure level over the total
working period.
An estimation of the level of exposure to vibration should also
take into account the times when the tool is switched off or
when it is running but not actually doing the job. This may sig-
nificantly reduce the exposure level over the total working
period.
Identify additional safety measures to protect the operator
from the effects of vibration such as: maintain the tool and the
accessories, keep the hands warm, organisation of work pat-
terns.
Figure Please observe
1
2
3
(triax vector sum) and uncertainty K
Page
255 – 256
257 – 258
259 – 260
19