Tool Specifications; Fastener Specifications - DeWalt DWFP12569 Manual De Instrucciones

Herramienta 2 en 1 para instalación de pisos
Ocultar thumbs Ver también para DWFP12569:
Tabla de contenido
Idiomas disponibles

Idiomas disponibles

DWFP12569_9R202311RA_DWLT_2in1 FLOORING TOOL MANUAL_MAN_JM:103697RevE_MIIIFS_MIIIFN.qxd 2012/9/25 上
DWFP12569 TOOL SPECIFICATIONS
All dimentions in inches unless otherwise specified
MODEL
LENGTH
DWFP12569
20.35" (517 mm)

FASTENER SPECIFICATIONS:

MODEL
DWFP12569
DWFP12569
TOOL AIR FITTING:
This tool uses a 1/4" N.P.T. male plug. The inside diameter should be .200" (5mm) or larger. The fitting
must be capable of discharging tool air pressure when disconnected from the air supply.
OPERATING PRESSURE:
70 to 100 p.s.i.g. (4.9 to 7.0 kg/cm²). Select the operating pressure within this range for best fastener
performance. DO NOT EXCEED THIS RECOMMENDED OPERATING PRESSURE.
AIR CONSUMPTION:
The DWFP12569 requires 3.7 cubic feet per minute (105 liters per minute) of free air to operate at the
rate of 60 fasteners per minute, at 80 p.s.i. (5.6 kg/cm2). Take the actual rate at which the tool will be run
to determine the amount of air required. For instance, if your fastener usage averages 30 fasteners per
minute, you need 50% of the tool's c.f.m. of free air which is required to operate the tool at 60 fasteners
per minute.
OPERATION
Caution Regarding Use of this Tool to Install Pre-finished Flooring
This DWFP12569 Flooring Tool was designed for use in installing unfinished hardwood flooring. It can be used
to install pre-finished flooring however caution must be used to ensure that the finish is not damaged by the tool.
It is recommended that the tool be tested on a sample section to be certain that the tool and technique of use
do not leave marks on the finish. This procedure should be followed before each job due to variations in flooring
and tool condition.
HEIGHT
WIDTH
22.08" (561 mm)
3.15" (80 mm)
FASTENER
CROWN WIDTH
BCS15xx
1/2" (13mm)
FLN-xxx
-
WEIGHT
10.85 lbs (4.9 kg)
GAUGE
FASTENER RANGE
15-1/2 Ga., 1/2"
1-1/2" (38mm) to
Crown Staples
2" (50mm)
16 Ga. "L" shape
1-1/2" (38mm) to
Cleat Nails
2" (50mm)
-4-
Tabla de contenido
loading

Tabla de contenido