Orbegozo BV 9600 Manual De Instrucciones página 15

Idiomas disponibles

Idiomas disponibles

BV 9600
- When removing the carafe from the base, open the cap or cover carefully, hot steam may escape. Be
careful the lid may be hot.
HELPFUL HINTS
- While the motor is running, ingredients can be added, with care, through the filler cap opening in the
center of the lid, except when hot liquids, they can splash and burn.
- To crush ice, place the ice cubes into the jar. Close the lid and place on the blender place. Press and
release the PULSE switch some times until the desired consistency is reached.
CARE AND CLEANING
Before first and after each use, clean it following these instructions.
Jar, lid and tamper cleaning
1. Remove the plug from the wall outlet.
2. Remove the jar from the blender base and empty the jar. Rinse the inside with warm water.
3. Then add 2 drops of liquid dishwashing soap and 1L of warm water to the jar.
4. Lock the cap into the lid and push the lid tightly onto the jar. Place the jar on the base.
5. With ON/OFF switch in OFF position, plug the blender.
6. Rotate the speed control to the lowest setting, place ON/OFF switch in ON position and increase the
speed slowly to maximum. Keep the high speed for 30-60 seconds.
7. Switch off the blender and unplug it.
8. Remove the jar from the base, empty and rinse it with clear water to remove all the soap from the jar.
9. Wipe the base with a damp cloth. If necessary, you can use a little mild detergent on the cloth.
10. Clean the tamper, lid and cap with warm soapy water.
11. Dry the jar and the other accessories with a soft cloth, place on the base and you can save it.
WARNING: use extreme caution when handling the jar, the blades are very sharp.
Base cleaning
1. Unplug from the wall outlet. Wipe exterior housing with soft damp soapy cloth. Take care any liquid
enters to interior of motor. Never use stiff brushes or abrasive cleaners.
2. Lift the centering platform off the base and wash it in warm soapy water. Rinse and dry.
3. When the switches become sticky, clean them with a cotton swab dampened with mild liquid detergent.
Dry them immediately.
Blades cleaning
1. Remove the blades with provided tool. Snap the
hooks into the nut's holes; hold the jar with the
other hand and turn the nut clockwise with the
tool.
2. Grasp the blades carefully, they are very sharp.
Clean them and put them back into position.
3. Tighten the nut with the tool turning to the left.
Make sure that it is tightly tightened to prevent
the blades dismounting and that the jar loses
liquid.
TROUBLESHOOTING
Blender does not operate (no power)
1. Ensure the plug is plugged and the plug works.
2. Unplug the base, remove the jar and press the overload reset button under the base.
My blender stops while blending
1. The blender is equipped with a resettable fuse, so if it has been running for a long time, it may have
warmed up. Unplug it, remove the jar and wait for the engine to cool down (5-20 minutes). After that time
it should work again, if not, press the reset button.
15
loading