Bosch sensixx B45L Instrucciones De Uso página 19

Problem
Water lows through the
holes on the soleplate.
Dirt comes out through
the soleplate.
The iron does not
produce any steam.
The ironed garment
turns dark and/or sticks
to the soleplate.
The soleplate turns
brown.
The appliance makes a
pumping sound.
ironing.
on the garment during
ironing.
the garment during use
of the "Pulse steam"
function.
The hose gets hot
during use.
Water leakage from the
boiler.
The iron does not stop
steaming after placing it
on the pad (2).
If the above does not solve the problem, get in touch with the authorised technical service.
You can download this manual from the local homepages of Bosch.
Possible causes
• The steam function is being used
before it has reached the correct
temperature.
• The water is condensing inside
the pipes because steam is being
used for the irst time or has not
been used for a long time.
• There is a build up of scale or
minerals in the steam tank.
• Chemical products or additives
have been used.
• The boiler is not switched on or
the water tank is empty.
• The steam regulation is set to the
minimum position.
• The selected temperature is
too high and has damaged the
garment.
• This is a regular consequence of
usage.
• Water is being pumped into the
steam tank.
• Water tank (1) is not correctly
inserted in the housing.
• The sound will not stop.
Steam release button activated
during a long period of time.
May be caused by steam
condensed on the ironing board.
Water spots are caused by steam
condensation in the hose when
cooling down after use.
This is normal.It is caused by the
steam passing through the hose
during steam ironing.
Filter (12) located at the side of the
appliance is loose.
"Pulse steam" function activated by
double click.
Solution
• Reduce the steam low when ironing at
low temperatures.
• Point the iron away from the ironing area
and press the steam release button until
steam is produced.
• Use tap water mixed 50% with distilled
or demineralised water. To prolong the
optimum steam function, mix tap water
with distilled water 1:1. If the tap water in
your district is very hard, mix tap water
with distilled water 1:2.
• Clean the soleplate with a damp cloth.
• Never add products to the water.
• Set the main power button (9) to the "I"
position (illuminated in red), and/or ill the
water tank.
• Increase the steam low (see section C).
• Select a suitable temperature for the
material being ironed and clean the
soleplate with a damp cloth.
• Clean the soleplate with a damp cloth.
• This is normal.
• Adjust the water tank correctly.
• If the sound will not stop, do not use
the steam generator and contact an
authorised technical service centre.
Use the steam release button at intervals.
This improves the ironing result as the
textiles will be dry and stay smooth better.
Wipe the textile cover of the ironing board,
and iron the spots without steam to dry
them.
Water drops stop coming out of the
soleplate after using the "Pulse steam"
function for some time.
Place the hose on the opposite side so that
you cannot touch the hose during ironing.
Tighten up the ilter.
Just press the trigger once again and the
iron will stop steaming at once.