Description Of Symbols; Standard Equipment; Preparing The Machine For Operation; Assembling The Handlebar - Viking MB 2 R Manual De Instrucciones

Tabla de contenido
Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 105
4.9 Disposal
Waste products such as used engine oil or
fuel, used lubricants, filters, batteries and
similar wearing parts can be harmful to
people, animals and the environment, and
must consequently be disposed of
properly.
Consult your recycling centre or your
specialist dealer for information on the
proper disposal of waste products. VIKING
recommends VIKING specialist dealers.
Ensure that old machines are properly
disposed of. Render the machine
unusable prior to disposal. In order to
prevent accidents, remove the ignition
lead, empty the fuel tank and drain the
engine oil in particular.
Risk of injury due to the mowing blade!
Always store an old lawn mower in a safe
place prior to scrapping. Ensure that the
machine and particularly the mowing blade
are kept out of the reach of children.

5. Description of symbols

Caution!
Read the instruction man-
ual before initial use.
Risk of injury!
Keep other persons out of
the danger area.
34
Risk of injury!
Detach the spark plug
socket before performing
work on the cutting tool or
maintenance and cleaning
work.
Risk of injury!
Keep your hands and feet
away from the blades.
Cutting tool runs on for sev-
eral seconds after switching
off (engine/blade brake).
MB 2 RT:
Start the engine.
Stop the engine.
Switch on self-propulsion.

6. Standard equipment

Item
Designation
A
Basic unit with handlebar
Instruction manual
Engine instruction manual
7. Preparing the machine for
operation
7.1 General
Risk of injury!
Observe the safety instructions in
the section "For your safety" (
● Place the machine on level and firm
ground when performing all the
operations described.

7.2 Assembling the handlebar

● Carefully fold up the
handlebar (1), ensuring that the
cables are not trapped.
● Tighten the pre-installed quick-
clamping devices (2) (they should
project by about one screw thread turn)
and fold upwards.
Check correct assembly
● The quick-clamping devices (1)
must be sufficiently tightened so
that they are pressed tightly against the
handlebar and the upper handlebar is
firmly connected to the lower
handlebar.
If the handlebar is not firmly installed or
the quick-clamping devices are not
correctly located, fold open the quick
clamping devices and adjust them to
the correct position by screwing out and
2
back in again.
Qty.
● Check that the cables (2, 3) and the
cable clip (4, MB 2 RC) are in the
1
correct position.
1
1
4.).
3
4
0478 111 9926 A - EN
Tabla de contenido
loading

Este manual también es adecuado para:

Mb 2 rcMb 2 rt

Tabla de contenido