Air Filter - Beta ALP 125 Manual De Instrucciones

3
B
A
GB
D
A

AIR FILTER

To have access to the filter unit A, remove
C
the saddle, the tank cover and the under-
saddle plastic shield, as described in
" Removal of body parts " on page 52.
• Remove the cover B by loosening the
screw C.
• Lift the battery holder, as shown in the
figure,
• Release the filter holder D.
• Remove the filter unit A.
• Pull out the holder D and take out the
sponge filter.
• Wash it with soap and water.
• Dry the filter.
•Wet the filter with filter oil. Remove any ex-
cess lubricant to prevent it from dripping.
• If necessary, also clean the inside of the
filter casing.
• Refit the parts, making sure of the seal of
the rubber gasket.
Note:
If the filter is very dirty, first wash it with a
special detergent and then with water and
shampoo.
If the filter is damaged, immediately re-
place it.
Clean the filter every time the vehicle is
used off road.
D
WARNING:
After working on the filter, ensure that noth-
ing is left inside the filter casing.
48