WIKA CPH62I0-S1 Manual De Instrucciones página 29

6. Commissioning, operation
Starting logging:
By pressing ´STORE/QUIT´ for 2 seconds the logger operation will be selected. The
display will show:
By pressing ´STORE/QUIT´ again briefly, the recording will be initiated.
After that the display shows 'St.XXXX' for a short time whenever a measurement is
recorded. XXXX is the number of the measuring 1 ... 4000 or 10000.
If the logger memory is full, the display will show:
The recording will be stopped automatically.
If the Low-Power-Logger-function is selected "Lo.Po = on" the device switches itself off
as soon as the memory becomes full.
Stopping the logging manually:
By pressing the ´STORE/QUIT´ key, recording can be manually interrupted. The follow-
ing choice then appears:
Stop recording
The selection can be made with the ´MAX´ key and ´MIN´ key. The ´STORE/QUIT´ key
confirms the selection.
If you try to switch off the instrument during a logging cycle, you will
also be asked if you wish to stop recording. The device can only be
switched off after the recording has been stopped!
The Auto-Power-Off-function is deactivated during logging!
WIKA operating instructions, model CPH62I0
Do not stop recording
GB
29