Electrical Connections; Power Supply - WIKA CPH62I0-S1 Manual De Instrucciones

4. Design and function
4. Tare: indicates that the tare function is activated.
5. SL: indicates, that the sea level function is activated.
6. Measuring unit: an arrow points to the chosen measuring unit.

4.4 Electrical connections

On the upper edge of the device are located the connector sockets for attaching the
CPH series pressure sensors, CH1 and CH2 (CH2 only with the 2-channel version),
(see chapter "6.6 Available pressure sensors"), as is the socket for the WIKA interface
cable (see chapter "6.5 The serial interface").
CH1
WARNING!
Operation as analogue output:
Connection via suitable cable.
Attention: The output mode must be configured via menu and influ-
ences battery life!
On the left side of the device the mains adapter socket for connecting the power
supply unit is located (see current CPH62I0 price list).

4.5 Power supply

Battery operation status
If ´bAt´ are shown in the lower display the battery is low and needs to be replaced. The
device will, however, work normally for a limited period. If ´bAt´ is shown in the upper
display the voltage is too low to operate the device; the battery will be completely flat.
WIKA operating instructions, model CPH62I0
CH2 (only for 2-channel version:
CPH62I0-S2)
Connection for WIKA interface
cable (RS-232/USB) or optional
analogue output
GB
15