Tabla de contenido
Idiomas disponibles
Idiomas disponibles
Accessories for this unit are available at the store the unit was purchased.
The use of any other accessory not recommended for use with
this tool could be hazardous. Use only accessories rated equal to or higher
than the rating of the air compressor.
TOOLS REqUIRED FOR ASSEMBLY
1 - 9/16" socket or open end wrench
1 - Electric Drill
UNPACkING
1.
Remove all packaging.
It may be necessary to brace or support one side of the outfit when
removing the pallet because the air compressor will have a tendency to tip.
2.
Remove and discard the screws and washers holding the compressor to the
pallet.
3. With the help of another person carefully remove air compressor from pallet
and place on a level surface.
This compressor was shipped with oil in the pump crankcase.
Check oil before operating air compressor, see Check Oil under Maintenance.
LOCATION OF THE AIR COMPRESSOR
•
Locate the air compressor in a clean, dry, and well ventilated area.
•
Located the air compressor at least 12" (30.5 cm) away from the wall or
other obstructions that will interfere with the flow of air.
•
Locate the air compressor as close to the main power supply as possible to
avoid using long lengths of electrical wiring. NOTE: Long lengths of electrical
wiring could cause power loss to the motor.
•
The air filter must be kept clear of obstructions which could reduce air flow
to the air compressor.
ANCHORING OF THE AIR COMPRESSOR
Risk of bursting. Excessive vibration can weaken the air tank
and cause an explosion. The compressor must be properly mounted.
The air compressor MUST be bolted to a level, solid concrete surface. Use 3/8"
lag screws, washers and concrete anchors. If help is needed anchoring the air
compressor consult a licensed contractor.
1.
Place the air compressor on a level,
solid concrete surface. Make sure
the concrete is in good condition
with no cracks or damage.
2.
Mark the surface using the holes
in the air compressor feet as a
template.
3.
Drill holes in the surface for the
concrete anchors. Install concrete
anchors.
4.
Line-up holes in surface with holes
in air compressor feet.
ACCESSORIES
ASSEMBLY
INSTALLATION
Washer
(supplied)
Shim Under
Washer (not
supplies
8 - ENG
3/8" Lag
Screw
(not supplied)
Surface Line
Concrete Anchor
(not supplied)
Tabla de contenido
