Tabla de contenido
Idiomas disponibles
Idiomas disponibles
UNPACKING
AND CLEANING
Carefully unpack the machine and all loose items from the shipping container(s). Remove the rust-preventative
oil from
unpainted surfaces using a soft cloth moistened with mineral spirits, paint thinner or denatured alcohol.
Do not use highly volatile solvents such as gasoline, naphtha, acetone or lacquer thinner for cleaning your
machine.
After cleaning, cover the unpainted surfaces with a good quality household floor paste wax.
For your own safety, do not connect the machine
to the power source until the machine
is
completely assembled
and you read and understand
the entire instruction manual
ASSEMBLY
TOOLS REQUIRED
1.
3mm Hex Wrench - provided
2.
4mm Hex Wrench - provided
3.
5mm Hex Wrench - provided
ASSEMBLY
TIME ESTIMATE
Assembly for this machine takes approximately
2 to 3 hours.
4. M8 Socket
- not provided
5. M8 Wrench - not provided
STAND ASSEMBLY
1.
Assemble
stand as shown
in Fig. 4, using parts
shown in Fig. 3. The brackets and legs are identified
with the same letter in both illustrations. Insert the
M8 x 16mm carriage head screws through the legs
and the brackets then place the 3/8" flat washers
followed
by M8 lock washers
on the screws and
secure with the M8 hex nuts. Only tighten nuts finger-
tight at this time. NOTE: The top lips of top brackets
(A) must fit on top of the front and back brackets
(B).
2.
Attach the four plastic feet (1) Fig. 4 to the bottom of
each leg (L).
Fig. 4
BAND SAW TO STAND ASSEMBLY
1.
Fig. 5 illustrates the four through holes (A) which will
be used to secure the band saw to the stand.
Fig. 5
2_
Place the band saw on top of the stand and line up
topthe bracketsh°les
(A)ofFig.the
5stand.with
the holes (D)Fig. 6 on the
8
Fig. 6
Tabla de contenido
